501843
23
Zoom out
Zoom in
Previous page
1/81
Next page
SummaSign Pro SL T-series Cutters User’s Manual
General Information 1-14
1.5 POWERING UP THE CUTTER
1.5.1 EARTHING (“GROUNDING”)
!
SAFETY WARNING
An insulated earth conductor must be installed as part of the branch
circuit that supplies power to the wall outlet to which the cutter is
connected. The earth conductor must have the same size, insulation
material, and thickness as the earthed and unearthed branch-circuit
supply conductors, but the insulating sheath should be green, or
green with yellow striping.
The earth conductor described above must be earthed at the
electrical distribution board, or, if power is supplied by a separate
system, at the power supply transformer motor / generator set.
The wall sockets into which the cutter is plugged must be of the
earthed type. The earth conductors serving said wall sockets must be
properly connected to earth.
CAUTION
Before plugging in the cutter's power cord to a power source, make
sure the cutter is set to the correct operating voltage (100 V, 120 V,
220 V, or 240 V AC).
(see section 3.2)
See Table 1-8 for the minimum and maximum operating voltage for the
different voltage ratings.
To check the operating voltage setting, locate the power entry module (shown
in Figure 1-1) on the cutter's rear panel. The power entry module shows four
possible voltage settings (100 V, 120 V, 220 V and 240 V). A pin next to one of
the voltage settings indicates the voltage setting currently selected for the
cutter. If this setting does not match the voltage supplied to your site, you will
have to change the voltage setting prior to powering up the cutter.
For information about the conversion of the cutter's operating voltage and the
exact fuse ratings, see Section 3.2.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Summa SummaSign Pro SL T-series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Summa SummaSign Pro SL T-series in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info