750861
9
Zoom out
Zoom in
Previous page
1/28
Next page
5
English
English
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
specifications, the playback with your receiver might not work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that the power
specifications might exceed the supported output of your receiver (5 V/800 mA). If so, please
connect your USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.
It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss of
information.
Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the USB
device via your receiver. Formatting requires entering the PIN code (default 0000)
STRONG cannot guarantee the playback of all files although extensions are listed, as it depends on
file size, codec, bit rate and resolution.
2.0 YOUR RECEIVER
2.1 PIN CODE
The PIN code is set by the user during the installation wizard. To modify the code, go to the Setting menu,
Parental Control > PIN-Code Change.
2.2 Front Panel
Fig.1
1. IR Sensor Receives the commands of the remote control
2. LED Display Displays channel number, time, videotext page or recording modes
3. Wi-Fi LED: Shows the status of your Wi-Fi connection. GREEN: connection OK. GREEN
BLINKING: data transmit. NO LIGHT: no Internet connections.
2.3 Top cover
Fig.2
1. Standby indicator:
Shows power state of the receiver. White LED: the receiver is on. Less white LED: the
receiver is in standby mode.
2.4 Side Panel
Fig.3
1. Smart card slot
To insert your tivùsat smart card with the golden chip facing down.
2. USB To connect your USB storage device
2.5 Rear Panel
Fig. 4
1. SAT IN To connect to the LNB of your satellite antenna for reception of satellite broadcast
signal
2. TV SCART To connect to TV using a SCART cable
3. S/PDIF (optical)
To connect to a digital amplifier or home theatre using a optical cable
4. HDMI To connect to the HDMI input of your TV set using a good quality HDMI cable
5. USB To connect your USB (3.0) storage device
6. ETHERNET To connect to a network switch, router or modem
7. IR To connect an infrared sensor (not included in the packaging)
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Strong SRT7840 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Strong SRT7840 in the language / languages: English as an attachment in your email.

The manual is 3,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Strong SRT7840

Strong SRT7840 User Manual - Italian - 31 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info