480560
23
Zoom out
Zoom in
Previous page
1/27
Next page
PART 2 • English
20
Problem Possible reason Remedy
Message “No
rights” or “Pay
TV channel”
The channel is scrambled. Either you have tuned to a channel which
is not part of your subscription or you have
not been patient enough to wait until the
channel of your basic subscription has
opened. If the problem persists, please
contact the support of your service
provider. Support contact information can
be found in the enclosed brochure.
Not possible
to control the
receiver with
the remote
control
Batteries are exhausted/wrongly
inserted.
Receiver powered or switched off.
Remote not aimed correctly.
IR sensor obstructed/disturbed.
Replace the batteries/check the correct
polarity.
Plug in/turn on the receiver.
Point your remote towards the front panel.
Check for obstructions, other possible
influence.
The IR sensor is covered up by
some object (obstacle between
RCU and receiver).
Remove obstacles between RCU and
receiver.
The receiver is switched off. Turn the receiver ON.
Forgot your
PIN code
Consult your local dealer
The receiver
switches off
automatically.
Auto standby function enabled. Disable/adjust auto standby. See chapter
6.3.4 for details.
8.0 TECHNICAL SPECIFICATION
Tuner
Input connector: IEC60169-2, female, 75 Ohm nominal
Input frequency range: VHF: 177.5 ~ 226.5 MHz
UHF: 474 ~ 858 MHz
Input signal level: -82 ~ -25 dBm
Antenna power: 5 V DC (+/- 0.5 V), max. 60 mA, short cut protected
Demodulation DVB-T/T2
Demodulation: Compliant to DVB-T (EN 300 744), DVB-T2 (EN 302 755)
Demodulation modes: QPSK, 16/64/256 QAM
Bandwidth: 7 or 8 MHz
FFT mode: 1K, 2K, 4K; 8K, 16K, 32K and extended normal
Guard interval: DVB-T: 1/32, 1/16, 1/8, 1/4;
DVB-T2: 1/128, 1/32, 1/16, 19/256, 1/8, 19/128, 1/4
Forward Error Corrections: DVB-T: 1/2, 2/3, 3/4, 5/6 7/8;
DVB-T2: 1/2, 3/5, 2/3, 3/4, 4/5 5/6
Video decoder
Profile: MPEG-2 MP @ ML, MP @ HL, MPEG-4 H.264/AVC
Input bit rate: Up to 30 Mbit/s
Aspect ratio: 4:3 and 16:9, Letterbox, Pan & Scan, Auto
Frame rate: 25 Hz for PAL
Video resolution: 576p, 720p, 1080i, 1080p
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Strong SRT 8525 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Strong SRT 8525 in the language / languages: English as an attachment in your email.

The manual is 1,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info