480560
22
Zoom out
Zoom in
Previous page
1/27
Next page
PART 2 • English
19
English
7.0 TROUBLESHOOTING
There may be many reasons that affect the correct operation of your receiver. If the receiver does
not work as you expect, please follow the steps outlined below. If after performing these operations,
the receiver does not work well, contact your dealer or service centre in your area. Do not open the
receiver cover. This action will damage the warranty seals and warranty repairs will be denied.
Problem Possible reason Remedy
The mode
indicator does
not light up
The power plug is not connected Check the connection of the receiver to the
main power.
The receiver is connected to the
main power through an extender
and the power is OFF.
Turn the power extender ON.
No signal
found
The antenna is disconnected. Connect the antenna cable.
The antenna is damaged/
misaligned.
Check the antenna and its position.
The cable between the antenna
and the receiver is damaged.
Possible bad connections in the
cable system.
Make sure that the cable is in good
condition.
Check proper connections.
Out of digital signal area. Check with your dealer.
The active antenna requires
turning the antenna power/
external power ON.
Make sure to enable antenna power from
the receiver menu (see chapter 6.2.1) or use
an external power supply.
No picture or
sound on TV
HDMI/SCART/AV is not selected on
your TV or the amplifier or is set
to a higher resolution than the TV
supports
TV is not switched on
Switch to correct TV input
Select lower resolution via receiver
Switch on TV
Connections are not done properly.
Quality of connected cables
insufficient.
Please ensure that the connections are
done correctly and are fitting well to the
connected input/output Check that the
quality of all cables is good. Reconnect all
cables between the receiver and TV set.
Video with
“mosaic”, audio
is noisy or A/V
disappears
from time to
time
Low signal level due to bad
weather conditions.
For good signal reception you may need to
realign/replace antenna.
The antenna is damaged or
covered by ice (winter time).
Damaged cable from antenna to
receiver.
Check the antenna and cables.
The indoor antenna has been
moved from a good position and
does not provide the necessary
signal level anymore.
Setup the antenna at a better position.
Check the signal level and quality (see
chapter 5.3.2)
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Strong SRT 8525 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Strong SRT 8525 in the language / languages: English as an attachment in your email.

The manual is 1,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info