480533
8
Zoom out
Zoom in
Previous page
1/15
Next page
PART 1 • English
5
English
27. 3/STOP Stops playback.
28. 0/REPEAT Repeats playback/stops repeat
29. RED Flexible functions in OSD MENU and Teletext
30. GREEN In no menu state changes resolution of HDMI output between 1080i, 720p
and 576i; flexible functions in OSD MENU and Teletext.
31. YELLOW In no menu state changes aspect ratio and aspect conversion of Video
outputs; flexible functions in OSD MENU and Teletext.
32.BLUE In no menu state displays Schedule menu for easy setup timers; flexible
functions in OSD MENU and Teletext.
2.5 Installing the Batteries
Fig. 4
Remove the battery cover from the remote control and put 2XAAA size batteries inside the compartment.
The diagram inside the battery compartment shows the correct way to install the batteries.
Note: The batteries should not be recharged, disassembled, electrically short-circuited, be mixed or used with other
types of batteries.
2.6 Using the Remote Control
Fig. 5
To use the remote control, point it towards the front of the digital receiver. The remote control has a range of up to 7
metres from the receiver at an angle of up to 60 degrees.
The remote control will not operate if its path is blocked.
Note: Sunlight or very bright light will decrease the sensitivity of the remote control.
3.0 CONNECTIONS
3.1 Connecting to TV Set
Fig. 6
3.2 Connecting to Digital Audio Amplifier, DVD/Video recorder
Fig. 6
4.0 FIRST TIME INSTALLATION
After all connections have been made properly, switch on TV and make sure the receiver is connected to the main power.
Then switch on the receiver. If you are using the receiver for the first time or restored to factory default, the Installation
Guide menu will appear on your TV screen. Use pq buttons to choose menu item.
1. OSD Language. Use tu buttons to select the language of your preference.
2. Country. Use tu buttons to select your country of residence
3. Antenna Power. Use tu buttons to set ON/OFF. Set to ON only if you use active indoor or outdoor
antenna. If it is set to ON the receiver will supply 5V power to the antenna. Please refer to the user manual
of your antenna.
4. Channel Type. Use tu buttons to select FTA/ALL. If you set FTA, the receiver will install only Free-To-Air
channels. If you set ALL, the receiver will install all available channels available in broadcast.
5. Select Search Channel and press u or OK to start Auto Scan.
The receiver will indicate progress of tuning. Once channel tuning is completed, the receiver will tune to the first
channel in the list. You are ready to watch TV.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Strong SRT 8110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Strong SRT 8110 in the language / languages: English as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info