790823
27
Zoom out
Zoom in
Previous page
1/44
Next page
27
FILLING & FLUSHING
Electric Boilers
Ensure that both ow and return isolation valves tted as part of your installation are fully open. Find the
Automatic Airvent behind the pump and ensure that the cap is freely moving and not screwed down in the closed
position. Connect the lling loop to the Water Replenishing connection, open the valve fully and allow the system
to ll slowly until the pressure gauge reads between 1 and 1.5 bar, at which point the replenishing valve should
be shut. Ensure that you add inhibitor to your system, refer the manufacturers guidance for diluation rates. For
the moment please leave the lling loop connected until you have purged the air out of the system.
HEATING SYSTEM INITIAL FILL:
FLUSHING:
The system must be ushed to 10% of mains PPM (chloride and otherwise) or lower to ensure that the water
system is not detrimental to the lifespan of the boiler. If the boiler is being installed into an existing heating
system, a power ush must be carried out on the radiators and pipework to remove any potential debris.
Ensuring that the isolating valve before the cold water inlet is fully open, open all hot water taps on the hot water
circuit 1 at a time and run until all air has ceased coming out of the tap, it is important to wait a moment until
all spluttering has stopped. If any air remains in the hot water element of the boiler when power is turned on the
water heating element can prematurely fail.
HOT WATER INITIAL FILL: (COMBINATION BOILERS ONLY)
27


Need help? Post your question in this forum.

Forumrules
1

Forum

strom-e-boiler

Reset search

  • After turning off heater, I cannot turn it back on. The Menu button does not work. Submitted on 5-4-2023 at 16:40

    Reply Report abuse
  • the front panel is flashing E5 and I can not change anything Submitted on 13-12-2022 at 13:27

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Strom E-Boiler at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Strom E-Boiler in the language / languages: English as an attachment in your email.

The manual is 3.36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info