813428

Stovax View 7 Inset High Output Boiler Inset Manual

6
Zoom out
Zoom in
Previous page
1/44
Next page
6
SAFETY CONTROLS
1.20 A high limit thermostat is fitted to the gravity flow pipe set at
80˚C.Thisthermostatshouldbeconnectedtothepumpso
thatthepumpisturnedonifthetemperatureexceeds80˚C.
This will prevent accidental boiling in the gravity circuit.
1.21 It is also recommended to fit a low limit thermostat on the
centralheatingreturnsetat45˚C.Thisthermostatwillturnthe
pumpoffifthereturntemperaturefallsbelow45˚C.Thiswill
prevent corrosion and condensation within the appliance.
NOTE – Further information on solid fuel central heating
systems can be found in the HETAS engineers training manual.
WARNING
Properly installed, operated and maintained, this
appliance will not emit fumes into the room.
Occasional fumes from de-ashing and refuelling
may occur.
Persistent fume emission is potentially
dangerous and must not be tolerated.
If fume emission does persist:
• Open doors and windows to ventilate the room.
• Leave the room.
• Allow fire to burn out and safely dispose of
fuel from the appliance.
• Check for chimney blockage and clean if
required.
• Do not attempt to relight until the cause of the
emission has been identified and corrected
• If necessary seek expert advice.
• All open flued appliances can be affected by
temporary atmospheric conditions which may
allow fumes to enter the house. Because of
this an electronic carbon monoxide detector
conforming to the latest edition of BSEN50292
must be fitted in the same room as the
appliance. The existence of an alarm must not
be considered a substitute for ensuring regular
servicing and maintenance of the appliance and
chimney system.
IF THE ALARM SOUNDS FOLLOW THE
INSTRUCTIONS GIVEN ABOVE.
Getting Started
2. Using the Appliance for the First Time
2.1 To allow the appliance to settle, and fixing glues and paint
to fully cure, operate the appliance at a low temperature for
first few days.
2.2 Do not touch the paint during the first period of use.
2.3 During this time the appliance may give off some unpleasant
odours. Keep the room well ventilated to avoid a build-up of
fumes.
2.4 Please be aware that, during use, rope seals may discolour.
This is normal.
CONDENSATION
CAUTION WHEN FILLING
2.5 When filling the boiler with water for the first time, the cold
water entering the water jacket can cause condensation to
form on the surfaces of the appliance (inside and outside).
2.6 In certain conditions this condensation could result in a
considerable amount of water, in some cases enough to fill
the bottom of the appliance. This could be even worse if the
house has recently been re-decorated, wet plastered or any
other work has been undertaken which could result in high
humidity.
2.7 Precautions must be taken to ensure that this build up of
condensate does not overflow from the appliance onto any
surrounding fabric of the room e.g. carpets.
NOTE - THIS CONDENSATION IS NORMAL DURING
FILLING AND DOES NOT INDICATE A FAULTY OR
LEAKING APPLIANCE.
NORMAL RUNNING
2.8 During normal running this condensation should be minimal
if the system is fitted with the low limit thermostat as detailed
in 1.21. This low limit thermostat prevents the system pump
from running until the appliance has reached temperature.
SEASONAL USE
2.9 If this appliance is unused for lengthy periods of time it
should be periodically checked to ensure that condensation
is not building up within the appliance.
NOTE – THIS CONDENSATION IS NORMAL AND DOES
NOT INDICATE A FAULTY OR LEAKING APPLIANCE.
If the appliance is going to be unused for very long periods
of time it is recommended to drain the system.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stovax View 7 Inset High Output Boiler Inset at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stovax View 7 Inset High Output Boiler Inset in the language / languages: English as an attachment in your email.

The manual is 4.77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info