52169
10
Zoom out
Zoom in
Previous page
1/106
Next page
9MS 191 T
English / USA
Fueling Instructions
Fuel your chainsaw in well-ventilated
areas, outdoors only. Always shut off the
engine and allow it to cool before
refueling. Gasoline vapor pressure may
build up inside the fueltank of a two cycle
engine depending on the fuel used, the
weather conditions, and the venting
system of the tank. In order to reduce the
risk of burns or other personal injury
from escaping gas vapor and fumes,
remove the fuel filler cap on the STIHL
product carefully so as to allow any
pressure build-up in the tank to release
slowly. Never remove fuel filler cap while
the engine is running.
Select bare ground for fueling and move
at least 10 feet (3 m) from fueling spot
before starting the engine.
Wipe off any spilled fuel before starting
your saw, and check for leakage.
!Warning!
Check for fuel leakage while refueling
and during operation. If fuel or oil
leakage is found, do not start or run the
engine until leak is fixed and spilled fuel
has been wiped away. Take care not to
get fuel on your clothing. If this happens,
change your clothing immediately.
!Warning!
Unit vibrations can cause an improperly
tightened fuel cap to loosen or come off
and spill quantities of fuel. In order to
reduce risk of fuel spillage and fire,
tighten the fuel cap by hand with as
much force as possible.
The screwdriver end of
the STIHL combination
wrench or other similar
tool can be used as an aid
in tightening slotted fuel
caps.
Starting
The chain brake must be engaged when
starting the saw.
!Warning!
Your chainsaw is a one-person saw.
Do not allow other persons to be near
the running chainsaw. Start and operate
your saw without assistance. For
specific starting instructions, see the
appropriate section of the owner's
manual. Proper starting methods reduce
the risk of injury. Do not drop start.
This method is very dangerous because
you may lose control of the saw. Place
the chainsaw on firm ground or other
solid surface in a clear area. Maintain
good balance and secure footing.
!Warning!
Be sure that the guide bar and chain are
clear of you and all other obstructions
and objects, including the ground. When
the engine is started, the engine speed
with the starting throttle lock engaged
will be fast enough for the clutch to
engage the sprocket and turn the chain,
if the chainbrake is not engaged. If the
running chain near the upper quadrant
of the bar nose touches any object, it
may cause kickback to occur (see
section on reactive forces).
001BA062 LÄ
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl MS191T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl MS191T in the language / languages: English as an attachment in your email.

The manual is 2,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info