52138
39
Zoom out
Zoom in
Previous page
1/54
Next page
A factory new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period.
As all moving parts have to bed in during
the break-in period, the frictional
resistances in the engine are greater
during this period. The engine develops
its maximum power after about 5 to 15
tank fillings.
Important:
Always disengage the chain brake
before opening the throttle. Running the
engine at higher revs with the chain
brake engaged (saw chain at a standstill)
will quickly damage the engine and chain
drive (clutch, chain brake).
Check chain tension frequently.
A new chain has to be retensioned more
often than one that has been in use for
some time.
Cold chain:
Tension is correct when chain fits snugly
against the underside of the bar and can
still be pulled along the bar by hand.
Retension if necessary -
see chapter “Tensioning the Saw Chain”.
Chain at operating temperature:
The chain stretches and begins to sag.
The drive links on the underside of the
bar must not come out of the bar groove
- the chain may otherwise jump off the
bar.
Retension the chain -
see chapter “Tensioning the Saw Chain”.
Always slacken off the chain again after
finishing work.
The chain contracts as it cools down.
If it is not slackened off, it may damage
the crankshaft and bearings.
After a long period of full-throttle
operation
Allow engine to run for a short while at
idling speed so that engine heat can be
dissipated by the flow of cooling air.
This helps protect engine-mounted
components (ignition, carburetor) from
thermal overload.
Slacken off the chain
if you have retensioned it at operating
temperature during cutting work. The
chain contracts as it cools down. If it is
not slackened off, it could damage the
crankshaft and bearings.
Before storing your saw
for a long period -
Drain and clean the fuel tank.
Run engine until carburetor is dry.
During Operation After Finishing WorkDuring Break-in Period
017, 018 37
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl 017 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl 017 in the language / languages: English as an attachment in your email.

The manual is 2,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info