575794
12
Zoom out
Zoom in
Previous page
1/16
Next page
ENGLISH
GB
Be careful when driving on slopes. No
sudden starting or stopping when mov-
ing up or down a slope. Never drive
across a slope. Move from the top down,
and from the bottom to the top.
The machine, equipped with original
accessories, may not be driven on slopes
greater than 10º in any direction.
Reduce the speed on slopes and when
making sharp turns to prevent the ma-
chine from tipping over or you losing
control of the machine.
Do not turn the steering wheel to full
lock when driving in top gear and at full
throttle. The machine can easily topple
over.
Keep hands and fingers well away from
articulated steering joint and seat
bracket. Risk of crushing injuries. Nev-
er operate the machine without the en-
gine casing.
SERVICE AND MAINTENANCE
SERVICE PROGRAM
In order to keep the machine in good condition, as
regards reliability and operational safety as well as
from an environmental perspective, STIGAs serv-
ice program should be followed.
The contents of this program can be found in the
attached service log.
We recommend that an authorised workshop car-
ries out every service. This guarantees that the
work is performed by trained personnel and with
genuine spare parts.
At every service, the service log should be
stamped. A “fully stamped” service log is a valua-
ble document that improves the machine’s second-
hand value.
PREPARATIONS
Unless otherwise stated, all service and mainte-
nance must be carried out on a stationary machine
when the engine is not running.
Prevent the machine from rolling by al-
ways applying the parking brake.
Prevent unintentional starting of the
engine by always stopping the engine,
disconnecting the spark plug cable
from the spark plug and earthing it.
Disconnect the negative cable from the
battery.
CLEANING
To reduce the risk of fire, keep the en-
gine, silencer/catalytic converter, bat-
tery and fuel tank free from grass,
leaves and oil.
To reduce the risk of fire, regularly
check the machine for oil and/or fuel
leakage.
When washing the machine with water under high
pressure, do not point the jet directly at the trans-
mission.
Do not point jets of water directly at the engine.
Use a brush or compressed air in order to clean it.
ENGINE OIL
(President - Comfort - Pro16 - Pro20)
Change the oil for the first time after 5 hours run-
ning, and then after every 50 hours running or once
a season. Change oil when the engine is warm.
Always use a good grade of oil (service grade SF,
SG or SH).
Change the oil more often (after 25 hours of oper-
ation or at least once a season) if the engine has to
operate under demanding conditions or if the am-
bient temperature is high.
The engine oil may be very hot if it is
drained off directly after the engine is
shut off. So allow the engine to cool a
few minutes before draining the oil.
1. Oil drain pipe (metal):
Unscrew the oil drain plug at the end of the pipe.
Collect the oil in a collection vessel. Then take
the oil to a recycling station. Do not allow oil to
get on the V-belts.
2. Screw in the oil drain plug. Make sure that the
fibre gasket and the O-ring inside the plug are not
damaged and that they are in the correct place.
3. Remove the dipstick and fill up with new oil.
Oil capacity:
Comfort, President - 1.4 l
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga PARK PRO 16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga PARK PRO 16 in the language / languages: English as an attachment in your email.

The manual is 3,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stiga PARK PRO 16

Stiga PARK PRO 16 User Manual - Dutch - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info