608691
10
Zoom out
Zoom in
Previous page
1/15
Next page
55
ENGLISH
EN
SAFETY SYSTEM
This machine is equipped with a safety system that
consists of:
- a switch at the brake pedal.
- a switch in the seat (Comfort, President) or the
seat bracket (other models).
- a switch at the power take-off engagement
lever.
In order to start the machine, the following are
necessary:
- brake pedal pressed down.
- driver sitting on seat.
- power take-off engagement lever in forward
position (i.e. power take-off disengaged).
Always check the operation of the
safety system before using the machine!
With the engine running and the driver sitting on
the seat, check as follows:
- press the drive pedal so that the machine starts
to move, release the drive pedal – the machine
must stop.
- press the drive pedal so that the machine starts
to move, engage the cruise control, lift your
weight off the seat – the machine must stop
(applies to Royal, Pro16, Pro20).
- press the drive pedal so that the machine starts
to move, engage the cruise control, press the
brake pedal – the machine must stop (applies to
Royal, Pro16, Pro20).
- engage the power take-off, lift your weight off
the seat – the engine must stop (applies to
Comfort, President, Royal, Pro16).
- engage the power take-off, lift your weight off
the seat – the power take-off must be
disengaged (applies to Pro20).
Do not use the machine if the safety
system is not working! Take the
machine to a service workshop for
inspection!
STARTING ENGINE
1. Open the fuel cock (fig. 12).
2. Make sure that the spark plug cable is properly
in place.
3. Check to make sure that the power take-off is
disengaged.
4. Do not keep your foot on the drive pedal.
5a. Comfort-President:
Starting cold engine – put the throttle control in the
choke position. Starting warm engine – put the
throttle control at full throttle (approx. 1 cm behind
the choke position).
5b. Royal-Pro16-Pro20 - Excellent:
Put the throttle control at full throttle. Starting cold
engine – pull the choke control out fully. Starting
warm engine – do not touch the choke control.
6. Depress the brake pedal fully.
7. Turn the ignition key and start the engine.
8a. Comfort-President:
Once the engine has started, move the throttle
control gradually to full throttle if the choke has
been used.
8b. Royal-Pro16-Pro20 - Excellent:
Once the engine has started, push the choke control
in gradually if it has been used.
9. When starting from cold, do not make the
machine work under load immediately, but let the
engine run for a few minutes first. This will allow
the oil to warm up.
When in use, always operate the engine at full
throttle.
STOPPING
Disengage the power take-off. Apply the parking
brake.
Allow the engine to idle 1 - 2 mins. Stop the engine
by turning off the starter key.
Shut off the petrol cock. This is particularly
important if the machine is to be transported on a
trailer for example.
If the machine is left unattended,
remove the spark plug cable from the
spark plug. Also remove the starter key.
The engine may be very warm
immediately after it is shut off. Do not
touch the silencer, cylinder or cooling
fins. This can cause burn injuries.
CATALYTIC CONVERTER
(Pro20 Cat)
The catalytic converter gets very hot during
operation. The heat remains for a long time after
the engine has been stopped. Be aware of the fire
risk.
Do not park in close proximity to
inflammable objects. Do not cover the
machine until the catalytic converter
has cooled down.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga Park EXCELLENT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga Park EXCELLENT in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info