608666
7
Zoom out
Zoom in
Previous page
1/7
Next page
ENGLISH
GB
Problem Possible causes
1. Mower does not start when safety
key is inserted and the safety han-
dle is pressed in
A. Check to make sure the safety key has been properly inserted and that the
engine protection is pressed in.
B. Remove safety key, turn mower over on side and check that blade is not
obstructed.
C. Is battery fully charged? Plug in charger and check lamps.
2. Mower stops while mowing (for
reason other than releasing the
safety handle).
A. The engine protection in the safety key has cut off power to protect
engine. Wait a couple of seconds for it to cool and then press in the
engine protection.
B. Remove safety key. Turn mower over and check that blade is free to turn.
Also check deck and ejector for clogging.
C. Mover is trying to cut too much grass. Raise it to higher cutting height
and try to start again.
D. Check to see if battery needs to be recharged.
3. Mower vibrates excessively or
makes excessive noise.
A. Remove safety key. Turn mower over to check if blade is properly tight-
ened.
B. Remove safety key. Turn mower over to check if blade has been bent,
damaged or worn out. Replace with an original blade.
C. Remove safety key. Turn mower over to check mower deck for damage.
If damaged, contact an authorised service dealer.
D. If no visible damage to mower or blade, return mower to an authorised
service dealer.
4. Mower runs but cutting perform-
ance is unsatisfactory and/or there
is a loss of power while mowing.
A. Was battery fully charged at the start?
B. Remove safety key. Turn mower over to check if:
-blade is correctly attached.
-blade is sharp.
-blade is bent, loose or damaged.
-deck and/or ejector and/or grass collector are clogged
C. Cutting height may be set too low, causing heavy strain on motor by try-
ing to cut too much grass. Raise to a higher cutting position.
5. Mower is hard to push. A. Mower is trying to cut too much grass (See problem 4, Cause C.)
B. Remove safety key. Turn mower over to check if all wheels rotate freely
and check them for damage. Obtain original replacement wheels from an
authorised service dealer.
6. Mower engine will not stop when
the safety handle is released.
A. Remove safety key to shut off motor. Mower can not then be started.
Contact an authorised service dealer.
7. Mower cannot finish cutting the
lawn on a single charge any more.
A. Was battery fully charged at the start?
B. Mower is trying to cut too much grass (See problem 4, Cause C.)
C. Contact an authorised service dealer for battery check.
8. Red lamp on charger does not
come on when charger is plugged
into wall outlet.
A. Wall outlet does not have power. (Verify with another electric device.)
B. The charger fuse may need to be replaced. Contact an authorised service
dealer
C. Charger or cord may be defective. Contact an authorised service dealer.
If the mower still doesn't work, despite measures taken according to this table, contact an authorised service dealer.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga Multiclip batt at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga Multiclip batt in the language / languages: English as an attachment in your email.

The manual is 0,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info