608666

Stiga Multiclip batt Manual

6
Zoom out
Zoom in
Previous page
1/7
Next page
ENGLISH
GB
MOWING TIPS
For best cutting results and to ensure that the bat-
tery lasts as long as possible, the following rules
should be followed:
• Drive the mower at a slow and even pace
• Try to avoid excessive starting and stopping, as
this draws a lot of current.
• Makesure that the motorisrunningat full speed
at all times when mowing.
• Mow regularly and often, especially when the
grass is growing quickly. Do not mow more than
a third of the total height of the grass during one
mowing session.
• Always use a sharp blade.
• Do not use the mower when it is raining or when
the grass is wet.
• Make sure that the underside of the cutting deck
is kept clean.
CUTTING HEIGHT
Do not set the cutting height so low that
the blade/blades can hit uneven ground.
When adjusting the cutting height, first-
ly pull out the safety key.
The cutting height can be adjusted to three posi-
tions by moving the wheel axles (fig. 9).
Position 1 = Lowest cutting height
Position 3 = Highest cutting height
MAINTENANCE
Take out the safety key and remove the
batterybefore any typeofmaintenance is
carried out.
CLEANING
The mower should be cleaned after each use. Use a
damp rag or sponge with a mild soap solution. Do
notuse wateror detergentsfor cleaning. Removeall
grass clippings which have gathered under the
cover.
CHANGING THE BLADE
Check,before andafter eachuse,thatthe
blade is tightly fixed and that it is not
damaged. A bent or damaged blade
should immediatelybe replaced. Use pro-
tective gloves to avoid cutting injuries.
Blunt and/or damaged blades tear off the grass and
make the lawn look ugly after mowing. New, well-
sharpened blades cut off the grass and ensure that it
looks green and fresh after it has been mown.
Remove the battery. Put the accompanying wrench
(36 mm) on the hexagon holder. Loosen the blade
nut with an adjustable wrench or another type of
fixed wrench (19 mm) (fig. 10). Turn the blade nut
in an anti-clockwise direction in ordertoremovethe
blade.
Fit the new blade and refit all the other parts exactly
as they were before they were dismantled, see fig.
10. Tighten the blade nut fully.
SHARPENING THE BLADE
Water grinding with whetstone or a grinding stone
should be used to sharpen the blade.
For safety reasons, the blade should not be sharp-
ened on an emery wheel. Too high a temperature
can result in the blade becoming brittle.
If the blade is sharpened, it must be bal-
anced afterwards to avoid vibration
damage (fig. 11).
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga Multiclip batt at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga Multiclip batt in the language / languages: English as an attachment in your email.

The manual is 0,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info