608479
84
Zoom out
Zoom in
Previous page
1/118
Next page
8
tenue par un ressort (2).
Relier dabord le câble rouge (3) au pôle positif 
(+), et ensuite le câble noir (4) au pôle négatif (–) 
à l’aide des vis fournies et en procédant dans 
l’ordre indiqué. 
Étendre sur les bornes de la graisse silicone, et 
vérier que le capuchon de protection du câble 
rouge (5) est correctement positionné. 
IMPORTANT Procéder toujours à la recharge
complète en suivant les indications contenues
dans le livret de la batterie.
IMPORTANT Afin d’éviter l’intervention de la
protection de la carte électronique, il est impératif
de ne pas de mettre le moteur en marche avant
la recharge complète!
3.5 INSTALLATION DU PARE-CHOCS
AVANT (si prévu)
Parce-chocs Type “I” (Fig. 3.5)
Monter le pare-chocs avant (1) sur la partie 
inférieure du châssis (2), en utilisant les quatre 
vis (3).
Parce-chocs Type “II” (Fig. 3.6)
Monter les deux supports (1) et (2) sur la partie 
inférieure du châssis (3) en utilisant les vis (4).
Fixer le pare-chocs avant (5) aux supports (1) et 
(2) en utilisant les vis (6) et les écrous (7).
3.6 MONTAGE ET COMPLÈTEMENT DE
LA PLAQUE POSTÉRIEURE (Fig. 3.7)
Monter les deux étriers inférieurs (1) et (2), en 
respectant le sens de montage qui est indiqué 
sur la gure, et les xer avec les vis (3) et les 
écrous (4), en les serrant à fond.
Enlever les deux vis (8), que l’on utilisera par la 
suite.
Monter la partie inférieure (5) de la plaque pos-
térieure, et la xer aux étriers inférieurs avec les 
vis (6) et les écrous (7), sans les serrer comp-
tement.
Achever la xation de la partie inférieure (5) 
de la plaque postérieure, en vissant à fond les 
deux vis centrales (8) qu’on avait enlevées et les 
quatre vis supérieures (9), puis serrer à fond les 
deux écrous inférieurs (7).
Insérer le levier (11) de l’indicateur de bac de 
ramassage plein dans son siège (12), et le pous-
ser vers le bas jusquau déclic.
Monter les deux supports du bac de ramassage 
(21) et (22), en respectant le sens de montage 
qui est indiqué sur la gure, et les xer avec les 
vis (23) et les rondelles élastiques (24), en les 
serrant à fond.
4. COMMANDES ET OUTILS
DE CONTRÔLE
4.1 VOLANT DE DIRECTION (Fig. 4.1 nº 1)
Il commande le braquage des roues avant.
4.2 LEVIER D’ACCÉLÉRATEUR (Fig. 4.1
nº 2)
Il règle le nombre de tours du moteur. Les posi-
tions, indiquées sur la plaque, indiquent:
«STARTER» démarrage à froid 
«LENT» vitesse minimum du moteur
«RAPIDE» vitesse maximum du moteur
–  La position «STARTER» provoque un enri-
chissement du mélange; elle doit être utilisée 
en cas de démarrage à froid et seulement 
pendant le temps strictement nécessaire.
–  Sur les trajets pour le déplacement de la ma-
chine, choisir une position intermédiaire entre 
«LENT» et «RAPIDE».
Durant la tonte, porter le levier en position
«RAPIDE».
4.2a COMMANDE STARTER (si prévue)
(Fig. 4.1 nº 2a)
La position Starter provoque un enrichissement 
du mélange; elle doit être utilisée seulement 
pendant le temps strictement nécessaire, en 
cas de démarrage à froid.
4.3 INTERRUPTEUR À CLÉ (Fig. 4.1 nº 3)
«ARRÊT»  correspond à tout éteint;
«ALLUMAGE PHARES» (si prévus);
«MARCHE» actionne tous les services;
«DÉMARRAGE» actionne le démarreur.
–  En relâchant la clé à partir de la position «DÉ-
MARRAGE», elle se remet automatiquement 
sur «MARCHE».
–  Après le démarrage du moteur, l’allumage des 
phares (si prévus) se fait en mettant la clé sur 
la position «ALLUMAGE PHARES».
–  pour les éteindre remettre la clé sur 
«MARCHE».
84


Need help? Post your question in this forum.

Forumrules
1

Forum

stiga-estate-3084-h

Reset search

  • the mower wont go into mowing drive when I lift the button
    Submitted on 7-3-2023 at 06:09

    Reply Report abuse
  • The engine cuts out if the forward pedal is pushed down.. it is not the seat cut out or the grass catcter off Submitted on 23-12-2022 at 01:10

    Reply Report abuse
  • I need information on replacing the Deck cutting belt Submitted on 28-5-2020 at 15:47

    Reply Report abuse
  • my stiga 3084H , with the wheels straight , the steering wheel is no longer aligned .The steering rods don't appear to be bent. Could the steering cog have jumped a tooth on the rack?
    Dave Submitted on 8-12-2018 at 20:29

    Reply Report abuse
  • HELP My stiga estate 3084h mower starts without having to press the foot brake and occasionally stops after a few seconds then it will not start leave it for a couple of minutes and it will start I have changed all the safety micro switches but it is still the same any suggestions please
    Thank you in advance Submitted on 2-7-2018 at 08:44

    Reply Report abuse
  • How do I level the cutting deck, it is 20mm higher on one side Submitted on 4-9-2017 at 16:25

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga ESTATE 3084 H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga ESTATE 3084 H in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stiga ESTATE 3084 H

Stiga ESTATE 3084 H User Manual - Danish, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish - 192 pages

Stiga ESTATE 3084 H Additional guide - All languages - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info