608479
75
Zoom out
Zoom in
Previous page
1/118
Next page
17
PROBLEM LIKELY CAUSE SOLUTION
3.  With the key on «START» the 
light comes on but the starter 
motor does not run
–  insuciently charged battery
–  malfunction on the starter relay
–  recharge the battery  (see 6.2.3)
–  contact your Dealer
4.  With the ignition key turned to 
«START» the starter motor runs 
but the engine does not start
–  insuciently charged battery
–  faulty fuel supply
–  faulty ignition
–  recharge the battery  (see 6.2.3)
–  check the level in the tank
(see 5.3.3)
–  open the fuel stopcock  (if tted)   
(see 5.4.1)
–  check the fuel lter
–  check that spark plug cap is 
securely tted
–  check that the electrodes are 
clean and have the correct gap
between them
5.  Starting is dicult or the engine 
runs erratically
–  faulty carburetion –  clean or replace the air lter
–  empty the fuel tank and rell with 
fresh fuel
–  check and replace the fuel lter if 
necessary
6.  Weak engine performance 
during cutting
–  forward speed too high in relation 
to cutting height
–  reduce the forward speed and/or 
raise the cutting height
(see 5.4.5)
7.  The engine shuts down whilst 
working
The safety device of the electronic 
circuit board has cut in due to:
–  the safety devices have cut in
Turn the ignition key to «STOP»
and look for the cause of the 
problem:
–  check that all starting conditions 
are met  (see 5.2.b)
8.  The cutting means do not 
engage or do not stop promptly 
when they are disengaged 
–  problems with the engagement 
mechanism
–  contact your Dealer
9.  Uneven mowing and poor grass 
collection
–  cutting-means assembly is not 
parallel to the ground
–  inecient cutting means;
–  forward speed too high 
compared to the height of grass 
being cut
–  collector channel is blocked
–  check the tyre pressure
(see 5.3.2)
–  reinstate the alignment of the 
cutting-means assembly in 
relation to the ground (see 6.3.1)
–  contact your Dealer
–  reduce the forward speed and/
or raise the cutting-means 
assembly (see 5.4.5)
–  wait for the grass to dry
–  remove the grass catcher and 
empty the collector channel
(see 5.4.7)
10. Unusual vibrations while 
working
–  cutting-means assembly is full 
of grass
–  the cutting means are 
unbalanced or loose
–  loose bolts and screws
–  clean the cutting means 
assembly (see 5.4.10)
–  contact your Dealer
–  check and tighten all the engine 
and frame bolts
11.  Uncertain or ineective braking –  the brake is not adjusted 
correctly
–  contact your Dealer
12.  Erratic forward movement, 
poor drive when going uphill or 
if the machine has a tendency 
to rear up
–  problems with the belt or the 
engagement device
–  contact your Dealer
75


Need help? Post your question in this forum.

Forumrules
1

Forum

stiga-estate-3084-h

Reset search

  • the mower wont go into mowing drive when I lift the button
    Submitted on 7-3-2023 at 06:09

    Reply Report abuse
  • The engine cuts out if the forward pedal is pushed down.. it is not the seat cut out or the grass catcter off Submitted on 23-12-2022 at 01:10

    Reply Report abuse
  • I need information on replacing the Deck cutting belt Submitted on 28-5-2020 at 15:47

    Reply Report abuse
  • my stiga 3084H , with the wheels straight , the steering wheel is no longer aligned .The steering rods don't appear to be bent. Could the steering cog have jumped a tooth on the rack?
    Dave Submitted on 8-12-2018 at 20:29

    Reply Report abuse
  • HELP My stiga estate 3084h mower starts without having to press the foot brake and occasionally stops after a few seconds then it will not start leave it for a couple of minutes and it will start I have changed all the safety micro switches but it is still the same any suggestions please
    Thank you in advance Submitted on 2-7-2018 at 08:44

    Reply Report abuse
  • How do I level the cutting deck, it is 20mm higher on one side Submitted on 4-9-2017 at 16:25

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga ESTATE 3084 H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga ESTATE 3084 H in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stiga ESTATE 3084 H

Stiga ESTATE 3084 H User Manual - Danish, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish - 192 pages

Stiga ESTATE 3084 H Additional guide - All languages - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info