564042

Stiga AUTOCLIP 720 S Manual

82
Zoom out
Zoom in
Previous page
1/788
Next page
24
User’s manual
EN
In sections of the path where it is
necessary to pass two parallel wires
(for example, to mark the boundary of a
owerbed), they must be laid on top of
each other at a minimum distance of 1
cm (0.40 inches).
corridor
< 70 cm (27,56 inc.)
CLOSED AREA
Max 35 cm
(13,78 inc.)
PRIMARY AREA
NO
Max 1 cm
(0,40 inc.)
Joining of the perimeter wire.
A buried wire or a wire laid on the ground
can be joined to other wires having the
same characteristics (see  gure). When
joining the two wires, make sure to use
self-sticking tape (for example, 3M
Scotch 23). Do not use insulating tape
or any other type of joining devices (wire
terminals, clamps, etc.).
1
3 4
2
SETUP OF THE ROBOT’S QUICK RE-ENTRY TO THE CHARGING STATION
To reduce the time for the robot’s re-entry to the charging station, setup the perimeter wire so
that the robot can easily change direction. In this way, the robot’s re-entry route is reduced.
To setup the quick re-entry route, position the perimeter wire along the path so that it forms a
triangle with one side equal to 50cm (19.7 in.) and two sides equal to 40 cm (15.75 in.) each.
Setup the wire for quick re-entry in a point where there is at least 200 cm (78.74 in.) of straight
wire in front of the station and at least 150 cm (59.05 in.) behind.
Do not set up the wire along the straight section immediately in front of the charging station
or near any obstacles. Make sure there are no obstacles along the re-entry path that may
obstruct the quick re-entry.
An incorrect setup of the robot’s quick re-entry may prevent the robot from
returning to the charging station quickly. When the robot travels along the
perimeter to reach a secondary area, it may not detect the quick re-entry setup.
… 82 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga AUTOCLIP 720 S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga AUTOCLIP 720 S in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 96,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info