564042

Stiga AUTOCLIP 720 S Manual

77
Zoom out
Zoom in
Previous page
1/788
Next page
19
User’s manual
EN
PREPARATION AND MARKING THE BOUNDARIES OF THE WORK AREAS
Preparation of the lawn to mow
1. Make sure the lawn to mow is even and does
not contain holes, stones or other obstacles.
Otherwise, prepare the lawn by  lling in any
holes and removing any obstacles. If some
obstacles cannot be removed, it is necessary
to properly mark these areas with the perimeter
wire.
2. Check that no areas of the lawn exceed the
allowable slopes (see “Technical Speci cations”).
When operating on slopes, the wheels may
slip when the robot detects the wire causing
it to fall outside the perimeter. To prevent
this inconvenience, “clawed" wheels can be
installed. If the kit is installed and the ground
conditions are suitable (compact, without
excessive depressions and holes, etc.), the
robot can work (within certain limits) outside the
maximum allowable slope limits (see the  gure).
Areas with slopes greater than those allowed
cannot be mowed with the robot. Therefore,
position the perimeter wire before the slope
so that it is not included in the area to mow.
Marking the boundary of the work area
3. Check the entire lawn surface and assess
whether it is necessary to divide it into
separate work areas. Before installing the
perimeter wire, check the entire path to make
this procedure easier. The illustration shows
an example of a lawn with the track for burying
the perimeter wire.
During installation, identify any secondary
areas and closed areas. A secondary area is a
section of lawn connected to the primary lawn
with a passage that is dif cult for the robot to
reach.
NO
21-35%
21-35%
0-20%
0-35%
Perimeter wire
35 cm (13,78 inc.)
NO
NO
OK
100 cm (39,3 Inc.)
35 cm (13,78 inc.)
35 %
24 v
Track for laying the perimeter wire
min. 70 cm / 27,56 inc
min. 70 cm / 27,56 inc
… 77 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga AUTOCLIP 720 S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga AUTOCLIP 720 S in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 96,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info