Manual Stiebel Eltron Thermocon BHE 75 (page 9 of 18) (English, German, Dutch, French)

457718

Zoom out

Zoom in

1/18

x the radiator does not

get warm?

x if liquid comes out of the

heater?

x when the sevice techni-

cian has been called?

Check whether . . .

. . . the ON/OFF button (

1) is switched on.

. . . the appropriate fuse in your fuse box has been connected or the residual current circuit breaker has

been switched off.

Remove the cause!

If the heater still does not warm up, call a qualified installer.

Switch the radiator off and then on:

– the LED indicator “appliance heating up” flashes 3 times, the measuring probe is damaged.

&DOODTXDOLÀHGLQVWDOOHU

– the LED indicator “appliance heating up” flashes 5 times, the mains voltage to the appliance is too high.

Switch the heating element off. &DOODTXDOLÀHGLQVWDOOHU

Switch off the unit and pull out the supply plug!

&DOODTXDOLÀHGLQVWDOOHURUVHUYLFHWHFKQLFDQ

Inform the service technician about the

type of unit (Typ) and it‘s number (Nr.)

that is found on the rating plate (20)!

What to do if …?

The installation (electrical work) and commis-

sioning as well as maintenance of this appli

ance must be carried out only by an approved

qualified installer in accordance with these

instructions.

Only remove the packaging of the unit and

accessories at the place of installation, taking

note of the additional package.

When unpacking, take care to ensure that no

accessories remain behind in the packaging

material.

2.1 Equipment description

8 Wall distance pipe

9 Screw5x40

10 Adjusting screw M4 x 10

11 Spacer

12 Clamp

13 Screw M5 x 30

14 Cap

15 Raw plug 8mm

16 Mount-hook

17 Cap

18 Power supply cable with plug,

1000 mm long

19 Fixing bolt

20 Rating plate

The towel rail radiator is for wall mounting only.

The appliance is ready for installation.The

heat-transfer-liquid, a water-glycol-mixture, will

be heated up by the heating element.

The electrical connection is by means of mains

plug.

With a protection level of IP 24 (splash proof),

the radiator can be installed where space is

restricted (take note of the information on

the protection range in 2.2 below).

2.2 Instructions and regulations

The appliance must not:

– Be operated in areas which are subject

WRWKHULVNRIÀUHRUH[SORVLRQGXHWR

chemicals, dust, gases or vapours;

– Be operated in the immediate vicinity of

pipes or containers which carry or con-

tain combustible or potentially explosive

substances;

– Be operated, at less as the minimum

clearance distances advised.

In workshops or other areas in which the

odour of waste gases, oil, petrol, etc. might

occur, or in which work is carried out in-

volving solvents and chemicals, there is a

risk of sustained odour burdens being en-

gendered, and possibly of dirt contamination

occurring.

x The appliance should only be installed on a

vertical wall resistant to temperatures above

90 °C

x The installation wall must have sufficient

load-bearing capacity (appliance weight, see

“Specifications”).

x Observe the minimum distances from ad-

joining surfaces of objects.

x The appliance should not be installed im-

mediately below a wall socket.

x All electrical connection and installation

work must be carried out in accordance

with the VDE regulations (0100), the regula-

tions of the competent water and electricity

supply companies as well as the appropriate

national and regional regulations.

x Follow the rating plate. The stated voltage

must be in accordance with the mains voltage.

x If the heating unit is installed in rooms with

a bath and/or a shower, the range of pro-

tection according to the I.E.E. Regulations- in

conformity with the information on the unit

rating plate - must be taken into account.

x The unit is to be fitted in such a way that

switching and control devices cannot be

touched by anyone in the bath or under the

shower.

x If it needs replacing, the power supply ca-

ble must only be replaced with an original

Stiebel Eltron spare by a qualified installer.

2.3 Installation

BHE 75

BTake the dimensions for drill holes from the

illustration of the BHE, depending on the

customer’s existing water connections, and

mark out on a wall with sufficient load-bear-

ing capacity. Observe minimum distances!

BInstall wall distance pipe (12) with enclosed

raw plugs Ø8 mm (19) and screws5x40

(13) depending on the construction of the

wall.

BPush the spacers (11) into the wall distance

pipe and screw into position with the ad-

justing screw M4 x 10 (10) (do not tighten).

BPosition the radiator with the two upper

cross-pipes on the upper spacers and secure

in position on the spacers by means of the

clamp (12) (M5 x 30 screw, 13).Then fix at

the bottom in the same way as at the top.

BLine up the radiator (push spacers into wall

bushes), tighten the adjusting screws in the

wall bushes at the top and put caps (14)on

the clamps.

BPlug in the mains plug (18).

BHE 75 L

B Determine the dimensions of drill-holes

according to the fixing bolts (19) or deter-

mine it from the dimensional drawing of the

BHC-L and mark it on a sufficient load-car

2. Installation instructions IRUTXDOLÀHGLQVWDOOHU

Typ: BH. . . . . Nr.: . . . . . . - . . . . - . . . . . .

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stiebel Eltron Thermocon BHE 75 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,24 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Stiebel Eltron Thermocon BHE 75 Manual

Product: