650328
5
Zoom out
Zoom in
Previous page
1/20
Next page
ENGLISH
 



7. Safety
7.1 General safety instructions
All required steps to complete commissioning must be carried
out by a heating contractor. During this process, these installation
instructions must be observed.
We guarantee trouble-free function and operational reliability
only if the original accessories and spare parts intended for the
appliance are used.
7.2 Instructions, standards and regulations
!
Material damage
Observe the type plate. The stated voltage must match
the mains voltage.
WARNING Risk of electrocution
All electrical connection and installation work must
be conducted in accordance with VDE regulations
(DINVDE0100) [or local regulations], the rules of your
local power supply utility and relevant national and local
regulations.
WARNING Risk of electrocution
Connection to the power supply is only possible as
a xed connection. The appliance must be able to be
separated from the mains power supply by an isolator
that disconnects all poles with at least 3 mm contact
separation.
Note
Observe all national and local instructions and regulations
relating to water connection.
- The protection IP 25 (hoseproof) can only be ensured with a
correctly fitted cable grommet.
- The specific electrical resistant of the water used must not
fall below that stated on the type plate. In a linked water
network, observe the lowest electrical water resistance
(see chapter "Application areas"). Your water supply utility
will advise you of the specific electrical water resistance or
conductivity.
7.3 Water installation
7.3.1 Cold water line
Permissible materials: Galvanised steel pipe, stainless steel pipe,
copper pipe or plastic pipe.
7.3.2 DHW line
Permissible materials: Stainless steel pipe, copper pipe or plastic
pipe.
!
Material damage
If plastic pipework is used, observe the most extreme
operating and fault conditions that can occur in the
appliance.
Note
Observe the plastic pipe manufacturer's instructions.
- A safety valve in the hot water pipe is not permissible.
- Never operate with valves intended for open vented
appliances.
7.4 Risk of frost
The installation of the appliance must be carried out in a room
free from the risk of frost.
Store the dismantled appliance in a room free from the risk
of frost, as water residues remaining inside the appliance can
freeze and cause damage.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiebel Eltron DHB-E 18 SLi 25A electronic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiebel Eltron DHB-E 18 SLi 25A electronic in the language / languages: English as an attachment in your email.

The manual is 7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stiebel Eltron DHB-E 18 SLi 25A electronic

Stiebel Eltron DHB-E 18 SLi 25A electronic Usermanual and installation guide - English, German, Dutch, French, Polish - 116 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info