742502
9
Zoom out
Zoom in
Previous page
1/24
Next page
| 9
8. Montage
- Achten Sie darauf, dass bauseits
ein ausreichender Leistungs-
querschnitt verlegt wurde.
- Achten Sie darauf, dass Sie das
Gerät mit einem Abstand von
mindestens 10 cm seitlich der
Steckdose montieren.
8.1 Montage des Gerätes
Zur Befestigung des Gerätes gehen
Sie wie folgt vor:
Befestigen Sie die Aufhänge-
leiste mit dem Ausschnitt der
Lasche nach oben.
Schrauben Sie die beiliegende
Auf hängeleiste waagerecht an
die Wand.
Verwenden Sie dazu geeig-
nete Be festigungsmaterialien
(Schrauben, Dübel) je nach
Wandart.
Mit dem horizontalen und vertika-
len Langloch ist ein Ausgleich beim
Verlaufen der Befestigungsbohrung
möglich.
D
Hängen Sie das Gerät mit den
oberen senkrechten Aussparun-
gen der Gerä terückwand in die
Aufhänge leiste ein.
Verschrauben Sie Gerät
und Aufhängeleiste mit der
Befesti gungsschraube.
E
1 Aufhängeleiste
2 Befestigungsschraube
8.2 Elektrischer Anschluss
Stecken Sie den Stecker in die
Steckdose.
9. Technische Daten
9.1 Sicherheitsabstände
Mindestabstände
Zum Luftaustrittsgitter 500 mm
Zu den Geräteseiten 100 mm
Zur Geräteoberseite 200 mm
Zur Geräteunterseite 100 mm
Zur Geräterückwand 26 mm
Zur Anschlussdose 100 mm
9.2 Datentabelle
CBS 20 S
185274
Anschlusslei-
stung
W 2000
Phasen 1/N
Nennspan-
nung
V 230
Frequenz Hz 50
Einstellbereich °C 5-35
Frostschutz-
stellung
°C 7
Höhe mm 400
Breite mm 275
Tiefe mm 121
Gewicht kg 3
Schutzart (IP) IP24
Schutzklasse II
Farbe
reinweiß, RAL
9010
9.3 Maße
F
9.4 Schaltplan
G
ENGLISH
OPERATION
1. General information
1.1 Document information
The chapter „Operation“ is intended
for appliance users and qualied con-
tractors.
The chapter „Installation“ is intended
for qualied contractors.
Note
Read these instructions ca-
refully before using the ap-
pliance and retain them for future
reference. Pass on the instructions
to any new user where appropriate.
1.2 Symbols in this docu-
ment
Note
Read these texts carefully.
This symbol indicates that you
have to do something. The acti-
on you need to take is described
step by step.
A
This symbol is a reference to Fig. A.
1.3 Units of measurement
Note
All measurements are given
in mm unless stated other-
wise.
2. Safety
2.1 Intended use
This appliance is designed to heat
living areas.
Any other use beyond that described
shall be deemed inappropriate. Ob-
servation of these instructions is also
part of the correct use of this appli-
ance. Any modications or conversi-
ons to the appliance void all warranty
rights.
This appliance is intended for do-
mestic use. It can be used safely by
untrained persons. The appliance
can also be used in a non-domestic
environment, e.g. in a small business,
as long as it is used in the same way.
2.2 Safety instructions
Observe the following safety instruc-
tions and regulations.
Operate the appliance only when
fully installed and with all safety
equipment tted.
!
WARNING Injury
- Keep children under the
age of 3 away from the ap-
pliance if constant supervision
cannot be guaranteed.
- Children from the age of 3 to 7
may switch the appliance on and
o, provided they are supervised
or have been instructed in the
safe operation of the appliance
and understand any risks that
may result. This is subject to the
appliance having been installed
as described. Children from the
age of 3 to 7 must not plug the
power cable into its socket nor
regulate the appliance.
- The appliance may be used by
children aged8 and older and
persons with reduced physical,
sensory or mental capabilities or
a lack of experience and know-
how, provided that they are su-
pervised or they have been ins-
tructed on how to use the appli-
ance safely and have understood
the resulting risks.
- Children must never play with
the appliance. Children must
never clean the appliance or
perform user maintenance un-
less they are supervised.
WARNING Burns
Never operate this appli-
ance...
- in rooms where the appliance is
at risk of re or explosion as a re-
sult of chemicals, dust, gases or
vapours.
- in the direct proximity of pipes or
receptacles that carry or contain
ammable or explosive materi-
als.
- if the minimum clearances to
adjacent surfaces are not main-
tained.
CAUTION Burns
Parts of the appliance can
get very hot and may cause
burns. Particular caution is advi-
sed when children or vulnerable
persons are present.
CAUTION Burns
To prevent risk caused by
the high limit safety cut-
out being reset unintentionally,
never supply the appliance via an
external switching facility, such
as a time switch, or connect it to
a power circuit that is regularly
switched on and o by a device.
2.3 Safety clearances
- Ensure that safety clearances
towards furniture and textiles or
other ammable or non-am-
mable materials are maintained.
This applies particularly to air
discharge grilles. See chapter
„Specication“.
- The hot air must be able to esca-
pe without hindrance.
3. Appliance descrip-
tion
The appliance is an electric direct
heater for installation on a wall. It is
suitable as, for example, a complete
heating system in bathrooms, or for
use between seasons and use as a
booster heater in smaller rooms, such
as hobby and guest rooms.
For heating, the room air is drawn in
by the appliance fan via apertures in
the back panel, heated by the hea-
ting element, and blown out evenly,
without sensation of a draught, via
the air discharge grille at the bottom
of the appliance.
A
You start the appliance by plugging
it into a suitable socket.
If the appliance overheats, the sa-
fety device automatically switches
o the heating elements and motor.
Proceed as follows:
Pull the plug from the socket.
Remove the cause of overhea-
ting (for example an obstruction
in front of the air inlet or outlet
grille, unusually high levels of
accumulated dirt, or similar
causes).
Let the appliance cool down for
> 15 minutes.
Put the plug back into the so-
cket and check that the applian-
ce functions correctly.
3.1 Standard delivery
- Rapid-action wall mounted hea-
ter with power cable and plug
- Wall mounting bracket
- Operating and installation
instructions
4. Operation
The required room temperature can
be innitely adjusted by means of
the temperature selector. The set
temperature of the room air is then
constantly maintained by repeated,
brief heating via the thermostat in
the appliance.
B
If you want to use the appliance as a
frost stat, turn the temperature selec-
tor anti-clockwise as far as it will go.
In this position, the thermostat swit-
ches the heating on automatically
if the room temperature drops to
approx. 7°C.
Note
To shut down, unplug the
appliance.
5. Cleaning, care and
maintenance
If a pale brownish discolouration ap-
pears on the appliance casing, wipe
this off as soon as possible with a
damp cloth. Clean the appliance
when cold with ordinary cleaning
products. Avoid abrasive or corrosive
cleaning products.
!
Material losses
Never spray cleaning spray
into the air slot.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiebel Eltron CBS 20 S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiebel Eltron CBS 20 S in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 3,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info