682526
50
Zoom out
Zoom in
Previous page
1/52
Next page
50 Sterling Elite2 XS-RS-Plus
18.2.3 Elite2 Plus Rear Wheel Removal
Use a flat bladed screw driver to carefully lever off •
the hub cover, (Fig.18.26).
With the wheel still on the ground: use a 6.0mm Allen •
key to loosen the 4 rim studs, but do not release the
studs more than two turns, (Fig.18.27).
Elevate the rear wheel by placing a jack under the •
relevant jack points, then secure with
blocks,(Fig.18.28).
Use the Allen key to finish releasing the studs.•
Remove the studs and washers, (Fig.18.29).•
Carefully remove the wheel, (Fig.18.30).•
Do not remove the drive hub from the drive shaft, •
(Fig.18.31).
Fig.18.27
Fig.18.26
Fig.18.29
Fig.18.28
Fig.18.31
Fig.18.30
Fig.18.33
Fig.18.32
Fig.18.35
Fig.18.34
Fig.18.37
Fig.18.36
Fig.18.38 Fig.18.39
18.3 CHANGING THE INNER TUBE (ALL)
Ensure any remaining air is expelled by pressing the•
valve with a small screwdriver and squeezing the
tyre, (Fig.18.32 - 18.33).
Use a 6.0mm Allen key to undo the FIVE rim studs,•
(Fig18.34).
Lift the outer rim off, (Fig.18.35).•
Lift the tyre of the inner rim, (Fig.18.36).•
Gently get hold of the inner tube just behind the •
valve.
Carefully feed the tube out of the tyre, (Fig.18.37).•
NOTE: Solid tyres are chemically bonded to the wheel
rims. These must be changed as a complete assembly.
To refit:
Place the tube inside the tyre and rest it on the outer •
rim.
Align the valve stem with the cut out on the rim, •
(Fig.18.38).
Face the valve stem outward, (Fig.18.38).•
Place the inner rim over the tyre, tube and outer rim.•
Align the cut out to fit over the valve stem and match •
it up to the cut out in the outer rim, (Fig.18.38).
Make sure the stud mounts are in line on both rims.•
Tighten the studs evenly in the sequence shown, •
going around once to close the rims and then again
to tighten fully taking, care not to pinch the tube,
(Fig.18.39).
Slowly inflate to the appropriate pressure. •
WARNING!
Do not use high pressure air delivery systems such •
as those found on garage forecourts, to inflate the
scooter tyres.
Always use a new inner tube.•
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sterling Elite 2 RS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sterling Elite 2 RS in the language / languages: English as an attachment in your email.

The manual is 3.6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sterling Elite 2 RS

Sterling Elite 2 RS User Manual - Dutch - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info