592456
11
Zoom out
Zoom in
Previous page
1/17
Next page
21
F
Dysfonctionnements
F
Déclaration de conformité
La lampe à détecteur n’est
pas sous tension
Fusible défectueux,
appareil hors circuit, câble
coupé
Court-circuit
Changer le fusible, mettre
l'interrupteur en circuit,
vérifier le câble à l’aide
d’un testeur de tension
Vérifier le branchement
La lampe à détecteur ne
s'allume pas
Pendant la journée, le
réglage de crépuscularité
est en position nocturne
Ampoule défectueuse
Interrupteur en position
ARRET
Fusible défectueux
Réglage incorrect de la
zone de détection
Régler à nouveau
Changer l’ampoule
Mettre en circuit
Changer le fusible,
éventuellement vérifier le
branchement
Régler à nouveau
La lampe à détecteur ne
s'éteint pas
Mouvement continu dans
la zone de détection
Contrôler la zone de
détection, éventuellement
la régler à nouveau ou la
masquer
La lampe à détecteur
s’allume et s’éteint
continuellement
Des animaux se dépla-
cent dans la zone de
détection
Orienter le détecteur plus
vers le haut ou le mas-
quer, modifier la zone ou
la masquer
La portée de la lampe à
détecteur change
Autres températures
ambiantes
Par temps froid, réduire la
portée en orientant le
détecteur plus vers le bas
Par temps chaud, le
remonter
La lampe à détecteur
intégré se déclenche de
façon intempestive
Le vent agite des arbres
et des arbustes dans la
zone de détection
Détection de voitures
passant sur la chaussée
Variations subites de
température dues aux
intempéries (vent, pluie,
neige) ou à des courants
d’air provenant de ventila-
teurs ou de fenêtres
ouvertes
Modifier la zone ou la
masquer
Modifier la zone, orienter
le détecteur plus vers le
bas
Modifier la zone, monter
l’appareil à un autre
endroit
Problème Cause Remède
Ce produit répond aux pre-
scriptions de la directive
basse-tension 73/23/CEE et
de la directive Compatibilité
Electromagnétique
(89/336/CEE).
20
GB
Troubleshooting
GB
Declaration of conformity
SensorLight without
power
Fuse faulty, not switched
on, break in wiring
Short-circuit
Replace fuse; switch on
power switch, check
wiring with voltage tester
Check connections
SensorLight will not
switch on
Twilight control set to
night-time mode during
daytime operation
Bulb faulty
Power switch OFF
Fuse faulty
Detection zone not
properly targeted
Adjust setting
Change bulb
Switch on
Replace fuse, check
connection if necessary
Re-adjust
SensorLight will not
switch off
Continuing movement in
detection zone
Check detection zone,
and re-adjust if necessary
SensorLight keeps
switching ON/OFF
Animals moving in
detection zone
Tilt sensor up or fit
shrouds to target sensor;
change zone, or shroud
Reach of SensorLight
changes
Varying ambient tempera-
tures
During cold weather, tilt
down sensor to shorten
range
Tilt up during warm
weather
SensorLight switches on
when it should not
Wind is moving trees and
bushes in detection zone
Cars in the street are
being detected
Sudden temperature
changes due to weather
(wind, rain, snow) or air
expelled from ventilators,
open windows
Change detection zone,
or shroud
Change detection zone,
tilt sensor down
Change detection zone,
change site of installation
Fault Cause Remedy
This product is in conformity
with standards of low
voltage in accordance with
the regulations 73/23/EEC,
89/336/EEC.
Serie 560_10spr 03.12.2009 13:36 Uhr Seite 21
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Steinel Serie 560 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Steinel Serie 560 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info