536223
11
Zoom out
Zoom in
Previous page
1/24
Next page
11
Use the unit with sufficient space around it. Keep the front side
and either right or left side of the unit clear.
Never use the unit on carpet or tablecloth (viny1) or any other
low-heat-resistant article.
Do not place a sheet of paper between the pot or the pan and
the unit. The paper may get burnt.
If the surface is cracked, switch off and take to the service cen-
ter immediately.
Do not block air intake or exhaust vent.
Do not touch the top plate shortly after removing the
pot or the pan, as the top plate will still be very hot.
Do not place near objects which are affected by magnet, such
as: radios, televisions, automatic-banking cards and cassette ta-
pes.
The supply cord must by replaced by qualified technicians.
Operation:
The appliance is equipped with a touch control display- All functions will be
activated by touching the surface.
Plug the appliance into the socket. A sound can be heard and all LED and the display
are on for one second. Now the appliance is in stand-by modus. Place a suitable pot in
the middle of the cooking area (min. diameter 12cm). When the ON/OFF
is touched
for one time a LED bellow heating is on and one LED is on above the ON/OFF
.
Attention!!! After 30seconds the appliance will go back into the stand-by modus,
when no function by touching
was chosen.
Power mode
This function is suitable for boiling water and soups.
Place the pot in the middle of the cooking area.
Touch ON/OFF one time and after that the function , the red LED bellow Heating
(Zeichen) is on and in the display there is 1200 is shown. The cooling fan starts work-
ing. With the buttons
or can the power be adjusted in steps of 200W. (200Watt
– 2000Watt)
During cooking the Wattage can be changed at any time.
The unit is equipped with an overheat protection. When the pot gets too hot, the
appliance will stop working, a sound can be heard and in the display E02 can be seen.
In that case, press the ON/OFF and cool the appliance down for some minutes. The
appliance will work after that without any problem.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Steba IK 300 SC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Steba IK 300 SC in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info