618998

StarTrac Pro S Treadmill Manual

52
Zoom out
Zoom in
Previous page
1/60
Next page
50 STAR TRAC PRO S / PRO / PRO ELITE TREADMILL O
WNER
’
S
M
ANUAL
Lowest Default Highest
Item Value Value Value Meaning
ENTERTAIN- - OFF - ON=Entertainment enabled.
MENT OFF=Entertainment disabled.
RAIL STOP - OFF - ON=Enables hardware stop for European units.
OFF=Disables hardware stop for European units.
10 REV 22.0 30.7 74.0 Inches of running belt travel for 10 flywheel revolutions, always measured in
inches. Nominal values are:
■
1.6" pulley: 27.5
■
1.7" pulley: 29.1
■
1.8" pulley: 30.7
■
2.1" pulley: 35.8
CNT/REV 31 31 125 Number of counts for each motor shaft revolution. Values are:
■
RPM sensor at flywheel notches: 31
■
RPM sensor at motor shaft optical disk: 125
MIN PWM 2 30 55 Pulse duty cycle to obtain the selected MN SPD. Divide MN PWM by 512 to
get % duty cycle.
1/2 MX 25 130 170 Pulse duty cycle to obtain 1/2 maximum speed. Divide 1/2 MX by 512 to get %
duty cycle.
MAX PWM 86 230 255 Pulse duty cycle to obtain the selected MX Spd. Divide MX PWM by 512 to get
% duty cycle.
ACCEL TIME 25 25 60 Time, in seconds, to reach maxmium speed from 0 mph (0 km/hr).
DECEL TIME 20 20 60 Time, in seconds, to reach 0 mph (0 km/hr) from maximum speed.
DATE 1.00 1.98 12.99 Treadmill manufacture date.
NO RAIL 0 0 255 Number of times Hand Rail Stop switch was down or disconnected on power-
STOP up since last reset.
KEY DOWN 0 0 255 Number of times key other than 5 or 8 was down on power-up since last reset.
SPEED CHG 0 0 255 Number of times speed changed suddenly more than 2 mph (UNITS=English)
or 2 km/hr (UNITS=Metric) since last reset.
ELEV STALL 0 0 255 Number of times elevation failed to change (stalled) since last reset.
ELEV RANGE 0 0 255 Number of times elevation was out of range (not between 0% and 15%) at
power-up since last reset.
ELEV LOST 0 0 255 After pressing S
TART and reaching 0% reset, the number of times elevation
went beyond 0% to 15%, since last reset.
NO MOTOR 0 0 255 Number of times the motor could not verify a load since last reset.
NO SENSOR 0 0 255 Number of time the sensor was inoperable since las reset.
ELEV ZERO 175 240 242 Representation of voltage to elevation motor to obtain 0% elevation. Multiply
ELEV ZERO by 0.019608 to get actual voltage.
ELEV MAX 25 57 170 Representation of voltage to elevation motor to obtain 15% (maximum) eleva-
tion (incline). Multiply ELEV MAX by 0.019608 to get actual voltage.
120 volt treadmill = 57
230 volt treadmill = 80
LAST DECK 0 0 65,535 Number of miles (UNITS=English), or km (UNITS=Metric) since the running
deck was last serviced or replaced.
LAST BELT 0 0 65,535 Number of miles (UNITS=English) or km (UNITS=Metric) since the running
belt was last replaced.
LAST MOTOR 0 0 65,535 Number of miles (UNITS=English), or km (UNITS=Metric) since the motor
brushes were last serviced or replaced.
MASTER PIN 0000 4321 9999 Master Personal Identification Number (PIN) for Personal Trainer.
… 52 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for StarTrac Pro S Treadmill at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of StarTrac Pro S Treadmill in the language / languages: English as an attachment in your email.

The manual is 3,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info