618991
15
Zoom out
Zoom in
Previous page
1/20
Next page
STEP #4: INSTALL LINKAGE BARS
1. Locate one of the Linkage Bars to install. On the end with the spherical rod, insert two misalignment bushings and two
O-rings, one bushing and one O-ring on each side of the rod end as shown below.
2. Slide the assembled rod end into the stainless steel strap bracket then install one (M10 X 40MM, SHOULDER BOLT),
two (M10 FLAT WASHERS), and a (M8, NYLOCK NUT). Tighten to specified torque using a 5MM hex key,13MM socket-
torque wrench.
3. Slide the lower end of the Linkage Bars onto the Leverage weight arm mount as shown below. Install one (M10 X
25MM, SOCKET HEAD BOLT) and one (M10 FLAT WASHER) and torque to the specified torque.
4. Repeat steps 1 thru 3 with the remaining Leverage Linkage Bars.
NOTE: When completed test the motion of the Leverage machine to ensure smooth quiet operation. Then
tighten all the screws at this time.
Page 15
STEP#4: Completed
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for StarTrac IP-L3005 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of StarTrac IP-L3005 in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info