618991
14
Zoom out
Zoom in
Previous page
1/20
Next page
STEP #3 ASSEMBLE UPPER ARM ASSY AND LOWER LEVERAGE ARMS :
1. Locate one of the Upper Arm Assembly ,one of the Lower Leverage Arm and slide them onto the corresponding shaft
as shown below. The side of the them that has the bearing and seal pre-installed will slide onto the corresponding shaft
first.
2.After the Upper Arm Assembly and Lower Leverage Arm have been slid onto the corresponding shaft install a fully
greased (20MM ID TAPERED BEARING) with the small diameter of the bearing going first. Next install a (3MM thick,
17MM ID WASHER) followed by a (TAB WASHER) then a (BEARING NUT) as shown in Fig: A. Note: the Tab washer
will have a tab protruding through the ID, this will need to align with the slot in the shaft.
3. Using the provided nut driver tool tighten the Bearing nut to the 7-9 Lbs-Ft torque. Check to make sure the bearings are
fully seated by wiggling the Lower Leverage arms and Upper Arm Assembly , if there is excessive play in the arm you
need to tighten the bearing nut more.
4. Once the nut is tight, use a small flat screwdriver to bend one of the tabs on the tab washer into one of the four notches
in the bearing nut as shown in Fig: B.
in the bearing nut as shown in Fig: B.
5. Repeat steps 1 thru 4 with the remaining Lower Leverage arms and Upper Arm Assembly as shown.
Page 14
STEP #3 Completed
Fig: A
Fig: B
ALIGN 1 OF THE
6 TABS WITH
SLOT IN NUT.
BEND TAB INTO
SLOT .
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for StarTrac IP-L3005 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of StarTrac IP-L3005 in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info