618989
20
Zoom out
Zoom in
Previous page
1/26
Next page
Star Trac Studio Series Group Cycle Bikes Owner’s Manual |
20
4. Tighten the adjustment screws evenly on both sides using the 10mm open end wrench.
6. While adjusting the chain tension, adjust the angle of the flywheel so it is straight front to rear and evenly
spaced within the frame side to side.
Note: When alignment is at the optimal adjustment, the chain will run smoother and quieter.
9. When the tension is set at a satisfactory level (i.e. there is no backlash in the pedals, and the chain runs
smooth and quiet when the pedals are turned), tighten the adjustment lock nuts and axle nuts on both
sides.
IMPORTANT: Be careful not to over tighten the chain. Adjust the tension just until you no longer feel
backlash at the crank arms. Overtightening the chain will cause the chain to wear prematurely, and will
cause the chain to ride loud and rough.
10. Install the axle nut cover and re-test the bike.
Note: If the chain is stretched beyond its ability to be adjusted, the chain must be replaced.
Checking and Adjusting Belt Tension on the Studio 5 and Studio 7
The belt on your Studio 5/Studio 7 bike has been factory set, and is very strong and durable. Also, it is
equipped with a self-tensioner to automatically adjust for slight changes in belt tension. Therefore, the belt
should not require adjustment. However, in the unlikely event that the belt slips, this procedure shows you how
to properly check and set the tension.
IMPORTANT: Improper belt adjustment will cause premature wear and may void the warranty.
IMPORTANT: Do not lubricate the belt. Lubricating the belt can damage the belt and cause the belt to slip, and
may void the warranty.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for StarTrac 7290 - Studio 7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of StarTrac 7290 - Studio 7 in the language / languages: English as an attachment in your email.

The manual is 1,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info