720594
30
Zoom out
Zoom in
Previous page
1/240
Next page
30
9. Cleaning, maintenance , transport and
storage
RISK OF INJURY
ATTENTION: For all work performed
on and for cutting tools, always wear
protective gloves.
To reduce the risk of unintentional start-
up, pull out the spark plug connector.
9.1 Cleaning
Use a damp cloth for cleaning the plastic parts. Do not
use detergents, solvents or sharp objects.
Depending on technical factors, during the course of the
work, wet grass and weeds grow around the drive axle
under the cutting guard.
Remove them, since otherwise the engine will be
overheated due to high friction.
9.2 Maintenance
9.2.1 Regular checks
Please note that the following information refer to a
normal usage. Under certain circumstances (longer daily
work, strong dust pollution, etc.) shorten the specified
intervals accordingly.
Prior to commencing work and after each tank filling:
Check for loose attachments especially at the cutting
equipment and shoulder strap, fuel leakage and
damaged parts such as cracks in the cutting assembly
(visual inspection).
Perform visual inspection also after every time the
device falls down and also for other impacts, to detect
significant defects.
Weekly inspection: Gearbox lubrication (also as per
requirement).
If required: Tighten accessible mounting bolts and nuts.
You will avoid excessive wear and damage to the device,
if you adhere to the specifications of this instructions
manual.
For all damages caused by failure to observe the
instructions given in this operating manual, the user is
responsible.
This also applies for non-authorized changes on the
device, use of non-authorized replacement parts,
attachment parts, work tools, unrelated use and usages
not as per intended purpose, consequential damages
due to use of defective components.
Hold the device as well as all cutting equipment and
protection system always in good operating condition.
G
B
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley STR-4 in 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley STR-4 in 1 in the language / languages: English, German, Danish, French, Italian, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 9,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info