Manual Stanley SPT-302-720 (page 25 of 233) (English, German, French, Italian, Finnish)

720581

Zoom out

Zoom in

1/233

8. Place belt(s) onto engine sheave(s).

9. Reinstall the chute crank lever.

Friction Wheel Replacement

If the snow thrower fails to drive with the drive

clutch engaged, and performing the clutch

control cable adjustment fails to correct the

problem, the friction wheel may need to be

replaced.

1. To prevent spillage, remove all fuel from

tank by running engine until it stops.

Remove the key to avoid unintended

starting and allow unit to cool completely.

2. Carefully pivot the snow thrower up and

forward so that it rests on the auger housing.

3. Remove the frame cover(s) from the

underside of the snow thrower by

removing the screws which secure the

cover(s).

4. Remove the right-hand wheel by removing

the axle lock pin.

6. Slip the drive belt off the pulley and between

friction wheel and friction wheel disc.

7. Remove and replace belt in the reverse order.

Holding down the drive clutch lever

will ease reinstallation of the belt.

If an assistant is available, you can also

separate the auger housing from the frame

assembly to replace belts.

1. Shut off engine, remove key, disconnect spark

plug wire and allow unit to cool completely.

2. Remove belt cover.

3. Remove the clevis pin and washer from the chute

crank lever to remove it from the lower branket.

4. Remove bottom cover to avoid bending it

when tipping unit apart.

5. Remove the screws securing auger housing to

the frame (two on each side).

Tip auger housing and frame apart.

6. Replace auger belt or drive belt.

7. Tip auger housing and frame back together

and secure with screws.

Holding down the auger clutch lever

will ease reconnection of the auger

housing and frame.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SPT-302-720 in the language / languages: English, German, French, Italian, Finnish as an attachment in your email.

The manual is 23,7 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Stanley SPT-302-720 Manual

Product: