720580

Stanley SPT-270-720 Manual

25
Zoom out
Zoom in
Previous page
1/233
Next page
25
8. Place belt(s) onto engine sheave(s).
9. Reinstall the chute crank lever.
Friction Wheel Replacement
If the snow thrower fails to drive with the drive
clutch engaged, and performing the clutch
control cable adjustment fails to correct the
problem, the friction wheel may need to be
replaced.
1. To prevent spillage, remove all fuel from
tank by running engine until it stops.
Remove the key to avoid unintended
starting and allow unit to cool completely.
2. Carefully pivot the snow thrower up and
forward so that it rests on the auger housing.
3. Remove the frame cover(s) from the
underside of the snow thrower by
removing the screws which secure the
cover(s).
4. Remove the right-hand wheel by removing
the axle lock pin.
6. Slip the drive belt off the pulley and between
friction wheel and friction wheel disc.
7. Remove and replace belt in the reverse order.
Holding down the drive clutch lever
will ease reinstallation of the belt.
If an assistant is available, you can also
separate the auger housing from the frame
assembly to replace belts.
1. Shut off engine, remove key, disconnect spark
plug wire and allow unit to cool completely.
2. Remove belt cover.
3. Remove the clevis pin and washer from the chute
crank lever to remove it from the lower branket.
4. Remove bottom cover to avoid bending it
when tipping unit apart.
5. Remove the screws securing auger housing to
the frame (two on each side).
Tip auger housing and frame apart.
6. Replace auger belt or drive belt.
7. Tip auger housing and frame back together
and secure with screws.
Holding down the auger clutch lever
will ease reconnection of the auger
housing and frame.
G
B
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley SPT-270-720 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SPT-270-720 in the language / languages: English, German, French, Italian, Finnish as an attachment in your email.

The manual is 23,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info