720579

Stanley SPT-182-570 Manual

12
Zoom out
Zoom in
Previous page
1/233
Next page
12
3. Secure the upper crank lever bracket (attached
to the crank lever) to the upper left side of the
handlebar with a locknut and two curved washers.
4. Apply grease to the spiral of the crank lever.
5. Insert the spiral end of the crank lever into the
lower bracket and secure with the flat washer and
clevis pin.
Tires
The tires are over-inflated at factory for
shipping purposes. Check the pressure in the
tires. Reduce or Increase equally in both tires
to the manufacturer’s recommended pressure.
Under any circumstance do not
exceed manufacturer’s recommended
pressure. Excessive pressure when
seating beads may cause tire/rim assembly
to burst with force sufficient to cause serious
injury. Refer to side wall of tire for recommended
pressure.
Equal tire pressure should be maintained
at all times. If the tire pressure is not
equal in both tires, the machine may not
travel in a straight path and the scraper
blade may wear unevenly.
Keep tires free of gasoline and oil,
which can harm rubber.
Skid Shoes
1. Move the machine to a level surface.
2. Support the auger blades so that they are 3mm
(1/8”) off the ground.
3. Check the scraper blade adjustment. The scraper
blade should be 3mm (1/8”) above and parallel to
a level ground. To adjust the scraper blade, loosen
the seven mounting screws (two on each side),
level the scraper blade, and tighten the mounting
screws.
4. Attach both skid shoes to the auger side plates
with the screws and nuts. Move the skid shoes
down as far as possible. Be sure both skid shoes
are adjusted evenly. Tighten securely.
Chute Clean-Out Tool
G
B
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley SPT-182-570 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SPT-182-570 in the language / languages: English, German, French, Italian, Finnish as an attachment in your email.

The manual is 23,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info