720579
10
Zoom out
Zoom in
Previous page
1/233
Next page
10
6. Assembly
Following the assembly directions below, you will
assemble the snow thrower in a few minutes
Engine
1. Remove wing nut and washer from the air
filter cover.
2. Rotate the air filter cover by 180o so that
the primer faces outside.
3. Install air filter cover and tighten wing nut.
Handlebars
1. Align the holes in the handlebars with the
side plates and secure handlebars with
the screws and the washers until they are
finger tight.
2. Remove the axle pins and slide the wheels
on the axle. Insert each axle pin through
the hole in each wheel hub and through the
hole in the axle.
3. Secure control panel to the handlebars with
screws, washers and nuts until they are
finger tight.
4. Ensure that the handles are at the same
height, and then tighten all the fasteners
securely.
G
B
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley SPT-182-570 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SPT-182-570 in the language / languages: English, German, French, Italian, Finnish as an attachment in your email.

The manual is 23,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info