720567

Stanley SGC-13000N-T Manual

13
Zoom out
Zoom in
Previous page
1/92
Next page
13
Idle Speed
Set throttle control lever to its “low” position
to reduce stress on the engine when compacting
is not being performed. Lowering the engine speed
to idle the engine will help extend the life of the
engine, as well as conserve fuel and reduce the
noise level of the machine.
MAINTENANCE
Maintaining your compactor will insure long
life to the machine and its components.
Preventive Maintenance
1. Turn off engine. Engine must be cool.
2. Keep the engine’s throttle lever in its SLOW
position, and remove spark plug wire from spark
plug and secure.
3. Inspect the general condition of the plate
compactor. Check for loose screws, misalignment
or binding of moving parts, cracked or broken
parts, and any other condition that may affect its
safe operation.
4. Remove all debris from the plate compactor with
a soft brush, vacuum, or compressed air. Then
use a premium quality lightweight machine oil to
lubricate all moving parts.
5. Clean the bottom of the compactor base as soon
as it begins to pick up soil being compacted. The
unit can not do a good job if the bottom surface is
not smooth and clean.
6. Replace spark plug wire.
Never use a “pressure washer” to clean
your plate compactor. Water can penetrate
tight areas of the unit and cause damage to
spindles, pulleys, bearings, or the engine. The use
of pressure washers will result in shortened life
and reduce serviceability.
Checking V-Belt(s)
To ensure optimum power transmission from
the engine to the eccentric shaft, the V-belt(s)
must be in good condition and operate under
proper tension.
1. Turn off engine. Engine must be cool.
2. Remove the belt guard to access the V-belt(s).
3. Check the condition of the V-belt(s). If any V-belt
is cracked, frayed, or glazed, it should be replaced
as soon as convenient.
4. Check the V-belt tension by squeezing them in
the center. The normal deflection on each side
should be 9mm (3/8” to 13mm (1/2” with moderate
pressure from your thumb or finger.
On new machines or after installing a new belt,
check belt tension after first 20 hours of operation.
Check and adjust belt every 50 hours thereafter.
Tensioning V-Belt
Proper belt tension is critical to good
performance.
Proper adjustment will assure long belt life.
Too much or too little belt tension will cause
premature belt failure.
Compactor with optional water sprinkler kit
1. If the plate compactor you bought is with
water tank, please pull the water tank up
from the chassis as shown.
G
B
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley SGC-13000N-T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SGC-13000N-T in the language / languages: English, German, Danish, Polish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 4,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info