612738
6
Zoom out
Zoom in
Previous page
1/9
Next page
5
DANGER
1. Remove all exterior and interior packaging. Check that ice basket and ice scoop is included. If any
part or accessory is missing, please contact our customer service.
2. Clean the interior with lukewarm water and a soft cloth. Remove the ice basket and wash it in warm
water.
3. Find a location for your ice maker that is protected from direct sunlight and other sources of heat (i.e.:
stove, furnace, radiator). Place the ice maker on a level surface. Maker sure that there is at least 5
inches of space between the back and sides of your ice maker and the wall.
4. Allow one hour for the refrigerant fluid to settle before plugging in the unit.
5. The appliance must be positioned so that the plug is accessible.
* Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility
of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not under any
circumstances, cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician.
3. This appliance requires a standard 120 volt, 60Hz electrical outlet with three-prong ground.
Before using your ice maker, it is strongly recommended to clean it thoroughly.
Remove the ice basket.
1. Turn the drain cap clockwise to drain out the water.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. The outside of the ice maker should be cleaned regularly with a mild detergent solution and warm
water.
4. Dry the interior and exterior with a soft cloth.
5. Close the drain cap.
6. When the machine is not in use, open water drain cap to drain water completely from water reservoir.
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER
CONNECTING YOUR ICE MAKER
!
CLEANING AND MAINTAI
NING YOUR ICE MAKER
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SPT USA IM-100 Ice Maker at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SPT USA IM-100 Ice Maker in the language / languages: English as an attachment in your email.

The manual is 0,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info