Manual SpinMaster Vectron Wave Air Hogs (page 4 of 4) (English)

584921

Zoom out

Zoom in

1/4

TROUBLESHOOTING cont’d...

Charger LED is

flashing Green.

Vectron

Wave will not

start or has lost power.

Vectron

Wave is flying

too low.

NOTE: If normal function of the product is disturbed or

interrupted, strong electro-magnetic interference may

be causing the issue. To reset product, turn it completely

off, then turn it back on. If normal operation does not

resume, move the product to another location and try

again. To ensure normal performance, change the

batteries, as low batteries may not allow full function.

1. Batteries in charger are low.

1. You have not set the motor switch

to “ON”.

2. Charger battery power is low.

3. Batteries (+) or (-) are not correctly

placed inside the battery compartment.

4. Vectron

Wave battery is low.

1. The batteries in the charger are drained.

2. Vectron

Wave’s battery is low.

3. Hair or debris may be caught in the rotor.

1. Install new batteries in charger.

1. Slide motor switch to “ON”.

2. Replace the charger batteries.

3. Be sure to align the (+) and (-) polarities

with the corresponding markings inside

the battery compartment.

4. Recharge Vectron

Wave.

1. Install new batteries in charger.

2. Recharge Vectron

Wave.

3. Remove hair or debris.

PROBLEM

SOLUTIONCAUSE

Spin Master Ltd., 450 Front Street West, Toronto,

ON M5V 1B6 Canada

Spin Master, Inc., PMB #10053, 300 International Drive,

Suite 100, Williamsville, NY 14221, USA

Spin Master Toys Far East Limited, Rm #1113, 11/F,

Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E.,

Kowloon, HK

North American Consumer Information

Phone: 1-800-622-8339

www.spinmaster.com

standards ASTM F963, EN71 Regulatory Requirements. • Please retain this information

for future reference. • Please remove all packaging materials before giving to children.

• An adult should periodically check this toy to ensure no damage or hazards exist, if

so, remove from use. • Children should be supervised during play. • Keep addresses

and phone numbers for future reference. • The item inside this package may vary from

the photographs and/or illustrations. Subject to one or more U.S. or world patents

under license from Go Wireless Ltd., including U.S. Patent No. 7,147,535 and U.S.

Design Patent No. D534467. MADE IN CHINA.

20019142, 20019143 NEN REV 0

IMPORTANT BATTERY INFORMATION

• Requires 6 x 1.5-V AA alkaline batteries (not included).

• Batteries are small objects.

• Replacement of batteries must be done by adults.

• Follow the polarity (+/-) diagram in the battery compartment.

• Promptly remove dead batteries from the toy.

• Dispose of used batteries properly.

• Remove batteries for prolonged storage

• DO NOT incinerate used batteries.

• DO NOT dispose of batteries in fire, as batteries may explode

or leak.

• DO NOT mix old and new batteries or types of batteries

(i.e. alkaline/standard).

• DO NOT use rechargeable batteries.

• DO NOT recharge non-rechargeable batteries.

• DO NOT short-circuit the supply terminals.

Your Vectron

Wave is equipped with a

Lithium Polymer battery.

WARNING:

• Never charge battery unattended.

• Charge battery in isolated area. Keep away from flammable

materials.

• Do not expose to direct sunlight.

• There is a risk of the batteries exploding, overheating, or

igniting. Do not disassemble, modify heat, or short circuit

the batteries. Do not place them in fires or leave them in

hot places.

• Do not drop or subject to strong impacts.

• Do not allow the batteries to get wet.

• Only charge the batteries with the specified Spin Master™

battery charger.

• Only use the batteries in the device specified by

Spin Master™.

• Carefully read the instruction guide, and use the batteries

correctly.

• In the unlikely event of leakage or explosion use sand or a

chemical fire extinguisher for the battery.

• Batteries must be recycled or disposed of properly.

This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) This device must accept any interference received, including interference that

may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B digital devices

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to

radio communications. Because this toy generates, uses, and can radiate radio frequency energy, there can be no guarantee that

interference will not occur. If this toy does cause interference to radio or television reception (you can check this by turning the

toy off and on while listening for the interference), one or more of the following measures may be useful: • Reorient or relocate the

receiving antenna • Increase the separation between the toy and the radio or the TV • Consult the dealer or an experienced TV-

radio technician for help. NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any

transmitter component (crystal, semiconductor, etc.) could result in a violation of FCC rules under part 15 and/or 95 and must be

expressly approved by Spin Master Ltd. or they could void the user’s authority to operate the equipment.

This class B digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of SpinMaster Vectron Wave Air Hogs in the language / languages: English as an attachment in your email.

The manual is 0,9 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

SpinMaster Vectron Wave Air Hogs Manual

Product: