744234
43
Zoom out
Zoom in
Previous page
1/53
Next page
GB
GB 43
Problem Cause, explanation Chapter
note Solution
Fire is difficult to
ignite
A sufficient air supply is not assured. 4.1.1 For lighting the fire or adding more firewood, move the actuating lever fully to the right.
The ambient temperature is above
about 15°C. The weather conditions
are unfavorable (e.g. fog). This is
referred to as an intervening period.
4.5 Fill the fireplace with a small amount of fuel and light it with the damper fully open (max. air flow).
There is a temperature inversion. That
means that the upper layers of the atmo-
sphere are warmer than the lower layers.
4.5 Fill the fireplace with a small amount of fuel and light it with the damper fully open (max. air flow).
The combustion air controller is not
fully opened. 4.1.1 Move the air actuating lever into its far right-hand position.
The external combustion air line is
not free. 2.2.2.2 Clean the combustion air line.
The chimney is not unobstructed. -Inform the chimney sweep.
There is not enough vacuum in the
chimney. -Light a small fire in the fireplace, following advice from your fireplace installer or chimney sweep.
Smoke escapes
when adding
wood
Air-extracting equipment is switched
on, e.g. kitchen extractor fan. -Ensure that all air-extracting equipment is switched off.
Wood added prematurely, on top of
unburned wood. 4.2.1 Do not add fresh firewood until there is a bed of hot embers in the combustion chamber.
The chimney is not unobstructed. -Inform the chimney sweep.
Your fireplace has not already reached
its operating temperature. -Burn down remaining wood until it forms a bed of hot embers, then add smaller pieces of firewood.
The door has been opened too wide. 4.2.1 Open the door slowly and carefully.
Combustion
too fast / wood
consumption too
high
The diameter of your stack of wood
is too small. 4.2.2 The ideal diameter for a stack of wood is about 25 cm.
The chimney draught is too strong. -Inform the chimney sweep. Perhaps increase combustion air flow to counteract choking action.
The combustion air flow has not been
reduced. 4.1.1 Leave the actuating lever in about its center position.
Ever since the lighting the fire, the fire
door has been slightly open. -Close the fire door!
The recommended wood feed quantity
has not been observed. -The proper amount of wood feed per hour for your tiled stove can be found in the technical data.
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spartherm Stovo S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spartherm Stovo S in the language / languages: English as an attachment in your email.

The manual is 3.7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spartherm Stovo S

Spartherm Stovo S User Manual - German - 52 pages

Spartherm Stovo S User Manual - Dutch - 53 pages

Spartherm Stovo S User Manual - Dutch - 53 pages

Spartherm Stovo S User Manual - Dutch - 44 pages

Spartherm Stovo S User Manual - French - 53 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info