744243
27
Zoom out
Zoom in
Previous page
1/53
Next page
GB
GB 27
approximately to the middle in steps. In the further course of combustion
and when the flue gas temperature drops, the combustion air quantity is
reduced further.
In doing so, the combustion air lever moves from the middle further to the
left.
Once the flue gas temperature has dropped far enough so that only embers
are in the combustion chamber, you are prompted to add fuel by an audible
tone. If the audible tone is not desired, this can be switched off by means
of the rocker switch. After the signal, you have approx. 10 minutes to add
more fuel without having to use a firelighter. If fuel is added and the fire
door is opened, the control opens the combustion air supply completely to
100% again. In doing so, the air control lever moves back completely to the
right again.
If no fuel is added after the flue gas temperature has dropped even further,
the combustion air is closed to a minimum. After the period of maintaining
the embers, the combustion chamber can be ventilated by opening the com-
bustion air for three minutes. This function allows the ember bed to reduce
further. After the venting process, the combustion air is
closed completely (0%) and the control shifts to standby mode (control
display off).
The correct operation of the S-Thermatik Mini combustion control is indi-
cated by a maintenance-free signal lamp that is mounted behind the fire
symbol in the bottom area of the stove and indicates the movement of the
air control lever.
If the air control lever does not move after opening the fire door, then S-Ther-
matik Mini mode must be carried out manually using a mechanical release
(changeover of the selector switch) to"manual" mode. The selector switch is
located on the supply air box and is visible when the lower front cladding of
the stove is opened. The combustion air can be adjusted by hand via the air
control lever. For more information about manual adjustment, refer to "4.1.1
Combustion air regulation".
The fireplace insert must never be put into operation with the
combustion air supply (combustion air lever all the way to the left)
closed!
Heat-up errors and the prompt for adding fuel are indicated by an audible
signal. The acoustic signal can be switched off using the rocker switched
mounted on the control housing.
3.2.2 FUNCTIONAL CHECK OF S-THERMATIK MINI
When commissioning the control each time (inserting the wall plug trans-
former into the socket or when shifting the selector switch from manual to
automatic), this carries out a self test when the fire door is closed. In doing
so, the air control lever moves from the left to the right and after a rest
period of max. 1 minute, back to the left again. The air control lever only
moves to the left if the door contact and the flue gas temperature sensor are
functional. The self test should be carried out when the combustion chamber
is cold. When the combustion chamber is hot, the air control lever does not
move completely to the left, it takes the respective position according to the
current flue gas temperature. When the stove is cold and after this self test,
the control shifts to stand-by mode and "waits" until the fire door is opened.
To perform the self-test on your own:
Move the selector switch to manual
Insert the wall plug transformer into the socket
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spartherm Passo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spartherm Passo in the language / languages: English as an attachment in your email.

The manual is 3.7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spartherm Passo

Spartherm Passo User Manual - German - 52 pages

Spartherm Passo User Manual - Dutch - 53 pages

Spartherm Passo User Manual - Dutch - 44 pages

Spartherm Passo User Manual - French - 53 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info