695793
11
Zoom out
Zoom in
Previous page
1/20
Next page
GB
GB 11
5. Place the canisters at the
requisite locations on the pillar
base. Connect the suction hoses
to the filler adapters using quick-
release couplings. (Fig. 4)
If you only wish to use one container,
pull the quick-release coupling off the unused filler adapter, or attach the
filler adapter to an empty canister.
Ensure that the hoses and cable are not jammed or damaged. Check to
ensure that the pillar is horizontal.
Using a spirit level, please only check if the burner is horizontal
while the unit is cold.
3.3.2 STARTING THE EBIOS-FIRE
1. Press the switch behind the flap door in the
base. The unit is now operational. Press this
switch at any time to switch the unit off. If the
ebios-fire is not going to be used for some time
it is advisable to switch it off at this switch,
as leaving the unit on stand-by will drain the
battery (Fig. 5).
2. To do this, press the top button on the radio
remote control (Fig. 6/6a). To shut it down,
press this button once again.
Please note: if you switch off the appliance while it is still warm, you
should wait for about 15 minutes before operating the appliance again. (the
red LED lamp flashes on). As soon as the time has elapsed, the appliance
can once again be switched on normally.
3. The ring on the switch will show red when the unit is in operation.
When switched on, the burner will beep twice in acknowledgment before
initiating the ignition routine. The ethanol collects in the fire tray and is
ignited there when the level is high enough. Wait until pumping stops
and the ignition phase comes to an end.
Never bend forward with your head directly over the fire tray, especially
during ignition!
Keep a safe distance of one metre until the fuel has been ignited by the
ignition system.
The flames can be hard to see at first, particularly when the fuel is cold.
The flames grow taller and brighter as the fire tray heats up. Misting up
of the glass tubes indicates that the fire is lit. It may take a moment for
a flame to spread right across the fire tray.
4. The ignition sequence will stop automatically after a certain time. If the
fuel has still not lit by then, switch the unit off and wait 10 seconds
before switching it on again. Another ignition sequence will then start.
This may happen when using the unit for the first time, if it has been
unused for some time or if the ethanol temperature is too low (it must be
at least 13 °C). If fuel is not pumped into the tray at the second attempt
Fig. 4
Fig. 5
Fig. 6
On / Off button
Fig. 6a
On / Off button
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spartherm Ebios fire - Tower at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spartherm Ebios fire - Tower in the language / languages: English as an attachment in your email.

The manual is 2.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spartherm Ebios fire - Tower

Spartherm Ebios fire - Tower Usermanual and installation guide - German - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info