695779
45
Zoom out
Zoom in
Previous page
1/57
Next page
45
compound, proceed as follows:
Open and secure the combustion chamber door. Apply a little lubricant
compound to the cotton swab and use it to coat the spring support (see Fig.
29b) on the door lock. Turn the locating roller on the body of the stove by
hand during this application process (see Fig. 29c).. Open and close the fire
door a few times and, if nec-
essary, apply the lubricant
compound once again.
Caution: Ensure that no
copper lubricant com-
pound makes contact
with cladding parts or
similar items! Remove
dirt and grime straightaway
with a cotton cloth. Never operate the equipment during intervening
periods.
6.4.2 MAINTENANCE OF THE WATER HEAT EXCHANGER
OF THE AMBIENTE A4 H2O / A6 H2O
The ambiente a4 H2O/a6 H2O must be maintained. The stove can only func-
tion at full efficiency if it is regularly and properly serviced. The technical
heating inspection and checking of all safety devices (thermal discharge
safety device etc.) is required yearly before the heating season. This
check must only be executed by a specialised company. We recommend
that you conclude a maintenance contract with your specialised company.
This guarantees that the annual safety inspection is reliably performed
before the heating season. The executed yearly safety inspections must be
documented!
6.4.3 VENTING THE WATER HEAT EXCHANGER OF
THE AMBIENTE A4 H2O / a6 H2O
The vent is located in the heating connection area, in the lower compart-
ment. The vent must be opened with a bleed key. A suitable container or
large towel should be kept at the ready to collect any water which leaks out.
A small tube can be attached to the vent. Upon opening the valve, water
firstly comes out of the vent line followed by air a few seconds later. Once
the air has escaped, the valve should be kept fully open for a further five
seconds.
The system must be vented:
Before and during initial commissioning.
Daily over the course of the following weeks until no more air escapes.
If sounds (air bubbles) can be heard in the heat exchanger.
If the pressure of the domestic water supply has been adjusted.
6.5 CLEANING THE WATER HEAT EXCHANGER OF THE
AMBIENTE a4 H
2
O / a6 H
2
O
Cleaning the water heat exchanger is absolutely necessary. Regularly and prop-
erly servicing allows the stove to function at full efficiency. Cleaning must always
be executed in cooled-down status!
Because the water heat exchanger directly cools down the flue gases and this
unavoidably results in deposits on the surfaces of the heat exchanger, these
surfaces must be cleaned with the integrated cleaning system on a regular basis.
The water heat exchanger should be cleaned once daily, or each time the
ash drawer is emptied, once it has cooled down. Regular operation of the
Chapter 6
Fig. 29c
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spartherm Ambiente at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spartherm Ambiente in the language / languages: English as an attachment in your email.

The manual is 4.14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spartherm Ambiente

Spartherm Ambiente Usermanual and installation guide - German - 48 pages

Spartherm Ambiente Usermanual and installation guide - Dutch - 48 pages

Spartherm Ambiente Usermanual and installation guide - French - 57 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info