611474
36
Zoom out
Zoom in
Previous page
1/60
Next page
34 Soundcraft MFXi MPMi User Guide Issue 1210
FX PROCESSOR CONTROLS (MFXi only)
1. Tempo Button - Tapping this button twice sets the Delay Time of the selected
program. The LED ashes to indicate current tempo. Can be tapped in time with
music source to synchronise the delay.
2. Store Button - Stores program modications to one of the program locations.
Press and hold for three seconds will store the preset in the current location.
The LED will ash rapidly during the store operation and then stay illuminated
for 1 second to show the operation is complete.
3. Pre Delay / Time/ Speed Knob - Controls Pre Delay of the reverbs or the rst
parameter (time or speed related) of the selected effect. The LED illuminates
when the parameter matches the stored setting.
4. Decay / Feedback/Depth Knob - Controls Decay of the reverbs or the
second parameter (feedback or depth related) of the selected effect. The LED
illuminates when the parameter matches the stored setting.
5. Variation - Controls Liveliness or Diffusion (depending on the reverb selected)
or the third parameter of the selected effect. The LED illuminates when the
parameter matches the stored setting.
6. Program Select Knob - Navigates through programs, turning to the required
program will initiate the loading of the program which take approximately 1
second. The knob can be rotated clockwise or anticlockwise and will alternate
between BANK A and BANK B every full rotation. The current bank is shown
by its illuminated LED, which ashes if the FX processor is muted. There is a
handy aide memoir of the programs printed on the front panel.
7. Clip LEDThis LED illuminates when either the incoming audio or the pro-
cessed audio (within the effect processor) overloads, and causes distortion of
the signal. If this illuminates reduce the FX Master Level (item 25, page 32).
Footswitch Input (not shown on diagram, see item 28 on page 28) - Using a
single pole, momentary footswitch inserted into the MUTE FX input the effects
processor can be muted/un-muted.
8. MUTE - This switch mutes the output of the FX processor. It doesn’t mute
the PFL signal.
9. FX TO AUX 1 - This pot routes a pre-fade signal to the Aux 1-pre bus.
10. FX TO AUX 2- This pot routes a pre-fade and a post-fade signal to the Aux
2-pre and Aux 2-post busses respectively.
11. EFFECTS FADER - This fader controls the level of the signal, from the FX
processor, routed to the main mix.
12. PFL - This switch routes a post-effects processor signal to the monitor
system.
FX BUS OUT (not shown on diagram, see item 27 on page 28) - This output
carries the signal from the FX bus. It could be used as a third Aux Output if
desired.
13. ‘SP’ LED - This indicates when a signal is present.
24-BIT DIGITAL
EFFECTS PROCESSOR
A: PRE-DEL
B: TME/SPD
A
B
:VARI
010
010
PFL
PK
SP
MUTE
FX
BANK A
BANK B
STORE
TEMPO
TAP
FX TO
AUX1
FX TO
AUX2
A: DECAY
B: FBK/DPTH
EFFECTS
-5
-10
-15
-20
-30
-40
0
3
4
5
7
9
10
11
1
2
6
8
12
13
S.HALL
L.HALL
V.HALL
D.HALL
S.PLT
L.PLT
V.PLT
D.PLT
ROOM
STUDI O
CHMBR
AMB
ARENA
GATED
REV
SPRING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
S.DLY
D.DLY
T.DLY
P.DLY
M.DLY
R.DLY
CHORUS
FLANGR
PHASR
TREM/P
VIBRTO
RV/DL S
RV/DL L
PHSDEL
ROTDEL
BANK A BANK B
KARAOKE
16
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft MPMi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft MPMi in the language / languages: English as an attachment in your email.

The manual is 2,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Soundcraft MPMi

Soundcraft MPMi User Manual - German - 35 pages

Soundcraft MPMi User Manual - French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info