611474
28
Zoom out
Zoom in
Previous page
1/60
Next page
26 Soundcraft MFXi MPMi User Guide Issue 1210
5 FX SEND (MFXi)
This control sets the level of the post-fade signal being sent to the FX bus; from there
it is routed to the FX processor. The FX Send is always post-fader.
6 BALANCE
This control sets the amount of the channel signal feeding the Left and Right MIX
buses, allowing you to balance the source in the stereo image. When the control is
turned fully right or left you feed only that side of the signal to the mix. Unity gain is
provided by the control in the centre-detented position.
7 MUTE
All outputs from the channel are enabled when the MUTE switch is released and muted
when the switch is down. The MUTE switch’s inbuilt LED glows when the channel is muted.
8 FADER
The 60mm FADER gives you smooth control of the overall signal level in the channel
strip, allowing precise balancing of the various source signals being mixed to the Mas-
ter Section. It is important that the input level is set correctly to give maximum travel
on the fader which should normally be used at around the “0” mark. See the “Initial
Setup” section on page 42 for help in setting the right level.
9 PFL
When the latching PFL switch is pressed, the pre-fade pre-mute signal is fed in mono
to the headphones, control room output and meters, where it replaces the MIX. The
SOLO LED on the Master section illuminates to warn that a PFL is active. The Left
and Right meters display the PFL signal in mono. This is a useful way of listening to
any required input signal without interrupting the main mix, for making adjustments
or tracing problems.
10 CHANNEL PEAK LED
This LED will light when the signal level approaches clipping at any of the two monitored
points: POST-EQ and POST-FADE.
11 SIGNAL PRESENT (SP) LED
The SP LED glows when a signal is present. The feed point for the LED is pre-EQ.
12 MIX/SUB
When this switch is up, the channel’s post-fade signal is routed to the Mix (left and
right) buses. When the switch is depressed, the post-fade signal is routed to the Sub-
group (left and right) buses.
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft MPMi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft MPMi in the language / languages: English as an attachment in your email.

The manual is 2,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Soundcraft MPMi

Soundcraft MPMi User Manual - German - 35 pages

Soundcraft MPMi User Manual - French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info