611474
19
Zoom out
Zoom in
Previous page
1/60
Next page
17Soundcraft MFXi MPMi User Guide Issue 1210
A ‘Y’ lead may be required to connect to equipment with separate send and
return jacks as shown below:
Stereo Inputs STEREO 1/2
These accept 3-pole 6.35mm (1/4”) jacks, or 2-pole mono jacks which will
automatically ground the ‘cold’ input. Use these inputs for sources such as
keyboards, drum machines, synths, tape machines or as returns from process-
ing units. The input is BALANCED for low noise and immunity from interfer-
ence, but you can use UNBALANCED sources by wiring up the jacks as shown,
although you should then keep cable lengths as short as possible to minimise
interference pick-up on the cable. Note that the ring must be grounded if the
source is unbalanced.
Mono sources can be fed to both paths by plugging into the Left jack only.
Mix Outputs
The MIX outputs are on XLR’s, wired as shown, and incorporate
impedance balancing, allowing long cable runs to balanced ampliers and
other equipment.
Aux and FX Bus Outputs
The Aux and FX Bus outputs are on 3-pole 6.35mm (1/4”) jack sockets,
wired as shown on the left, and are impedance-balanced, allowing long
cable runs to balanced ampliers and other equipment.
Headphones
The PHONES output is a 3-pole 6.35mm (1/4”) jack, wired as a stereo
output as shown, ideally for headphones of 32 or greater.
8 headphones are not recommended.
From
Impedance-Balanced
Output
Signal +
Signal +
Screen
Screen
Signal -
Signal -
To External Device
To External Device
Experience has shown that sometimes it is better
not to connect screen at external device end.
Balanced Connection
Unbalanced Connection
From
Impedance-Balanced
Output
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft MPMi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft MPMi in the language / languages: English as an attachment in your email.

The manual is 2,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Soundcraft MPMi

Soundcraft MPMi User Manual - German - 35 pages

Soundcraft MPMi User Manual - French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info