611455
12
Zoom out
Zoom in
Previous page
1/48
Next page
12
Polarity (Phase)
You will probably be familiar with the concept of polarity in electrical
signals and this is of particular importance to balanced audio signals.
Just as a balanced signal is highly effective at cancelling out unwanted
interference, so two microphones picking up the same signal can cancel
out, or cause serious degradation of the signal if one of the cables has
the +ve and -ve wires reversed. This phase reversal can be a real prob-
lem when microphones are close together and you should therefore al-
ways take care to connect pins correctly when wiring audio cables.
Grounding and Shielding
For optimum performance use balanced connections where possible
and ensure that all signals are referenced to a solid, noise-free earthing
point and that all signal cables have their screens connected to ground.
In some unusual circumstances, to avoid earth or ground ‘loops’ ensure
that all cable screens and other signal earths are connected to ground
only at their source and not at both ends.
If the use of unbalanced connections is unavoidable, you can minimise
noise by following these wiring guidelines:
On INPUTS, unbalance at the source and use a twin screened
cable as though it were balanced.
On OUTPUTS, connect the signal to the +ve output pin, and the
ground of the output device to -ve. If a twin screened cable is
used, connect the screen only at the mixer end.
Avoid running audio cables or placing audio equipment close to
thyristor dimmer units or power cables.
Noise immunity is improved significantly by the use of low imped-
ance sources, such as good quality professional microphones or
the outputs from most modern audio equipment. Avoid cheaper
high impedance microphones, which may suffer from interference
over long cable runs, even with well-made cables.
Grounding and shielding is still seen as a black art, and the suggestions
above are only guidelines. If your system still hums, an earth/ground
loop is the most likely cause. Two examples of how an earth loop can
occur are shown below.
Warning!
Under NO circumstances must the AC power mains earth be disconnected
from the mains lead.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft MFX12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft MFX12 in the language / languages: English as an attachment in your email.

The manual is 2,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info