611445
15
Zoom out
Zoom in
Previous page
1/48
Next page
USER GUIDE
13
STEREO RETURNS RET-1/2/3/4
These accept RCA phono jacks to allow easy connection to hi-fi equipment or DAT players. The input is
unbalanced, and ideal for pre-show music sources or signals that do not require any EQ or effects. These
can also be used as effect returns using cables described later in this document.
STEREO INPUTS STE-1/2/3/4
These accept 3-pole `A gauge jacks, or 2-pole mono jacks which will automatically ground the ‘cold’ input.
Use these inputs for sources such as keyboards, drum machines, synths, tape machines or as returns from
processing units. The input is BALANCED for low noise and immunity from interference, but you can use
UNBALANCED sources by wiring up the jacks as shown, although you should then keep cable lengths as
short as possible to minimise interference pick-up on the cable. Note that the ring must be grounded if the
source is unbalanced.
Mono sources can be fed to both paths by plugging into the Left jack only.
MIX INSERTS
The unbalanced, pre-fade Mix insert point is a break in the output signal path to allow the connection of, for
example, a compressor/limiter or graphic equaliser. The Insert is a 3-pole A gauge jack socket which is
normally bypassed. When a jack is inserted, the signal path is broken, just before the mix fader.
The mix signal appears on the TIP of the plug and is returned on the RING. A ‘Y’ lead may be required to
connect to equipment with separate send and return jacks as shown below:
MIX & SUB OUTPUTS
The MIX and SUB outputs are on 3-pole A gauge jack sockets, wired as shown, and incorporate impedance
balancing, allowing long cable runs to balanced amplifiers and other equipment.
AUX OUTPUTS
The Aux outputs are on 3-pole A gauge jack sockets, wired as shown on the left, and are balanced, allowing
long cable runs to balanced amplifiers and other equipment.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft M4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft M4 in the language / languages: English as an attachment in your email.

The manual is 4,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Soundcraft M4

Soundcraft M4 User Manual - German - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info