611444
26
Zoom out
Zoom in
Previous page
1/48
Next page
USER GUIDE
24
You are now ready to start building the mix and this should be done progressively, listening carefully for
each component in the mix and watching the meters for any hint of overload. If this occurs, back off the
appropriate Channel Fader slightly until the level is out of the red segments, or adjust the Master Faders.
Remember that the mixer is a mixer, not an amplifier. Increasing the overall level is the job of the amplifier,
and if it is impossible to provide adequate level, it is probable that the amplifier is too small for the applica-
tion. Choose your amplifier carefully, and do not try to compensate for lack of power by using the mixer to
increase output level.
NOTE:
The level of any source signal in the final output is affected by many factors, principally the Input Gain con-
trol, Channel Fader and Mix Faders. You should try to use only as much microphone gain as required to
achieve a good balance between signals, with the faders set as described above.
If the input gain is set too high, the channel fader will need to be pulled down too far in compensation to
leave enough travel for successful mixing and there is a greater risk of feedback because small fader
movements will have a very significant effect on output level. Also there will be a chance of distortion as
the signal overloads the channel and causes clipping.
If the gain is set too low, you will not find enough gain on the faders to bring the signal up to an adequate
level, and backgound hiss will be more noticeable.
This is illustrated below:
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft M Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft M Series in the language / languages: English as an attachment in your email.

The manual is 4,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Soundcraft M Series

Soundcraft M Series User Manual - German - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info