611476
16
Zoom out
Zoom in
Previous page
1/48
Next page
16
9 PAN
This control sets the amount of the channel signal feeding the MIX L & R or SUB
L & R busses (see SUB & MIX below), allowing you to move the source smoothly
across the stereo image. When the control is turned fully right or left you are
able to route the signal at unity gain to either left or right outputs individually.
A mono sum of the post-fader channel signal is also fed to the Mono output,
unaffected by the position of the PAN control.
10 MUTE
All outputs from the channel except inserts and pre-fade Direct outputs are
active when the MUTE switch is released and muted when the switch is down,
allowing levels to be pre-set before the signal is required.
11 SUB
The channel signal may be routed to the SUB L & R busses by pressing this
switch, with the channel signal fed proportionately to left or right depending on
the position of the PAN control.
12 MIX
The channel signal may be routed to the MIX L & R busses by pressing this
switch, with the channel signal fed proportionately to left or right depending on
the position of the PAN control.
13 SOLO/PK
The FX16ii provides versatile non-destructive PFL (Pre-Fade-Listen) and SOLO-
IN-PLACE monitoring, as selected by the SOLO MODE switch on the Master
section.
PFL
When the latching SOLO switch is pressed, the pre-fade, post-EQ signal is fed
to the headphones, control room output and meters, where it replaces the
selected monitor source. The adjacent LED illuminates to identify the selected
channel and the PFL/AFL LED on the Master section illuminates to warn that a
PFL is active. This is a useful way of listening to any required input signal
without interrupting the main mix, for making adjustments or tracing problems.
When the PFL switch is released the LED serves as a PEAK indicator which
illuminates approximately 4dB before clipping to give warning of a possible
overload. The signal is sampled both pre-insert and after the HF EQ.
Note: It is normal for the Peak/PFL LED to go off slowly when the switch is
pressed.
SOLO-IN-PLACE
In contrast to PFL, SOLO-IN-PLACE mode allows an individual channel, or
selection of channels to be monitored in isolation from the rest of the mix, but
at the correct mix levels and with all sends and effects active. With SOLO
MODE active, pressing any one or more SOLO switches mutes all channels
which are not SOLOed, leaving only the selected channels in the mix. When the
SOLO switches are released the original mix is restored.
Note that when SOLO MODE is active, pressing any SOLO switch interrupts
the main MIX, and should therefore not be used during live performance.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft FX 16ii at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft FX 16ii in the language / languages: English as an attachment in your email.

The manual is 2,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Soundcraft FX 16ii

Soundcraft FX 16ii User Manual - German - 48 pages

Soundcraft FX 16ii User Manual - French - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info