611451
26
Zoom out
Zoom in
Previous page
1/60
Next page
24
Soundcraft EFX/EPM User Guide Issue 1210
your microphone manufacturer for guidance).
Mics should always be plugged in, and all output faders set to minimum
before switching the Phantom Power ON to avoid damage to external
equipment
2 POWER INDICATOR
This LED lights to show when power is connected to the console.
3 MASTER FADERS
The MASTER FADERS set the nal level of the MIX outputs, and separate
faders are provided for each output. These should normally be set close
to the ‘0’ mark if the input GAIN settings have been correctly set, to give
maximum travel on the faders for smoothest control.
4 MIX OUTPUTS, INSERTS & MONO OUTPUT
The Mix LEFT and RIGHT outputs are sent from the XLR sockets as imped-
ance-balanced signals. The Mix INSERT points are on 3-pole A gauge
jacks and are unbalanced. The MONO OUTPUT (EFX only) caries a mono
sum of the left and right mix signals on a 3-pole A gauge jack, the output
is impedance-balanced.
5 BARGRAPH METERS
The three-colour peak reading BARGRAPH METERS normally show the level
of the MIX RIGHT and MIX LEFT outputs, giving you a constant warning of ex-
cessive peaks in the signal which might cause overloading. Aim to keep the
signal within the amber segments at peak levels for best performance.
Similarly, if the output level is too low and hardly registering at all on the
meters, the level of background noise may become signicant. Take care
to set up the input levels for best performance.
When any PFL switch is pressed, the meters switch to show the selected
PFL signal on both meters, in mono; the PFL ACTIVE LED also lights.
MASTER SECTION (EFX)
1 PHANTOM POWER
Many professional condenser mics need
PHANTOM POWER, which is a method
of sending a powering voltage down
the same wires as the mic signal. Press
the switch to enable the +48V power to
all of the MIC inputs. The adjacent LED
illuminates when the power is active.
WARNING: TAKE CARE when
using unbalanced mics
which may be damaged by
the phantom power volt-
age. Balanced dynamic mics
can normally be used with
phantom power switched on (contact
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft EFX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft EFX in the language / languages: English as an attachment in your email.

The manual is 3,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info