680561
14
Zoom out
Zoom in
Previous page
1/30
Next page
Installation
t
– 14
Mount the controller housing and
connect
Selection of the installation variant
ATTENTION!
1. Control or regulating units in a xed position must be
mounted within sight of the door. They may not, however,
be mounted close to moving parts and must be at least
1.5 m above the ground.
NOTE!
Cables should always be permanently installed. Install cables
in such a manner that it is possible to extend the power
supply lines for variant A (e.g. install with a slack loop if the
cable is to be installed at a right angle to the C-rail).
ATTENTION!
Danger due to electric current!
Only touch the controller (4) on the outer edge.
Don't touch the electronic components.
22
1
2
4
3
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
Reset
Radio
LED2
LED1
Reset
Radio
LED2
LED1
Take off the lamp cover (1). Unscrew the screws (2) and take off the
cover (3), remove the controller (4).
Installation variant A/B
B23
1,6m
3
1
2
4
2
4
1,6m
3
1
A23
2
4
2
4
Choose a suitable location for the controller housing (1) close to an
existing wall socket (2). The minimum height above the ground is 1.6 m.
ATTENTION!
Bear in mind the installation position of the controller
housing (1). Ensure that the maximum length of the control
cable (3) of 6900 mm is not exceeded.
Install the control cable (3) (24 V) to the controller housing (1) in the
garage. Do not plug in the power mains plug (4) yet.
24
25
2
1
2
3
4
5
6
1
2
3
4
5
6
5
34
4
95
S6
1
2
5
6
ca 150
ATTENTION!
Do not drill into the power supply line to the wall socket!
Do not plug in the power mains plug yet.
Drill two holes (Ø 6 x 40 mm deep). Insert anchor ttings (2) into the
drill holes.
Afx the controller housing with two screws (1) and two washers (6),
align the unit properly and rmly tighten the screws.
Insert the end of the control cable (5) through the back of the controller
housing (4).
Connect the control cable (5): With hinged double doors, connect the
wire marked with 3 (green) to terminal 3 and the wire marked with 4 (red)
to terminal 4 of the direct connector (2). Shorten the control cable (5)
if necessary.
NOTE!
With hinged double doors, connect the wire marked with 3
(green) to terminal 4 and the wire marked with 4 (red) to termi-
nal 3 of the direct connector (2).
25
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sommer Duo vision 500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sommer Duo vision 500 in the language / languages: English as an attachment in your email.

The manual is 6,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sommer Duo vision 500

Sommer Duo vision 500 Usermanual and installation guide - German - 30 pages

Sommer Duo vision 500 Usermanual and installation guide - Dutch - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info