Manual Solo 880 (page 64 of 249) (English, German, Dutch, French, Spanish)

655959

Zoom out

Zoom in

1/249

Preparing for use

ENGLISH 22

Loosen and turn assembly flange (j)

x Put the wheel guard on a level surface with the

assembly flange (j) pointing up (screws (g) of the

assembly flange point up).

x Turn out screw (k).

Hold the nut below the assembly flange with flat

pliers.

x Twist the assembly flange against the wheel

guard so that the receptacle bore for the

screw (k) is located between the centre stop and

the right stop (m) on the wheel guard. The

assembly flange is hard to twist. Securely hold

the wheel guard when twisting.

Limit wheel guard rotating angle with screw (k)

x Turn in screw (k) again.

For this, guide the nut (n) below the assembly

flange with flat pliers and hold it when turning in

the screw.

Turning of the wheel guard

is limited by the stops

on the wheel guard between which the nut can

be moved.

Install cutting device in the outer position

x Put the cutting device on the cutting device

carrier in the outer position. For this, guide both

screws (g) of the assembly flange through the

oblong holes and put the ribbed belt support (i)

into the ribbed belt.

x Check that the ribbed belt is running freely.

Correct placement of the ribbed belt if required.

x Put on the ribbed belt cover (14) again.

djust the ribbed belt tension

x Screw both attachment nuts (d) of the ribbed belt

cover onto the assembly flange screws. Only

tighten the nuts manually so that the ribbed belt

tension can still be set.

x Turn ribbed belt tension screw (13) towards the

right, e.g. clockwise, to increase the ribbed belt

tension). The correct tension is reached when

the square nut (e) is on the centre mark, i.e.

between "+" and 

x Tighten both attachment nuts (d) firmly.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Solo 880 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 2,49 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Solo 880 Manual

Product: