658837
20
Zoom out
Zoom in
Previous page
1/46
Next page
Preparing the equipment for use - Assembly of the guide bar and chain
ENGLISH 20
E
N
G
4. Preparing the equipment for use
4.1 Assembly of the guide bar and chain
Undo the retaining nuts on the rail cover (12).
Take off the rail cover.
When setting up the tool for the first time, remove
the cardboard disc inserted at the factory as
transport protection underneath the rail cover
before installing the guide bar.
On used saws, clean the rail contact surface and
the oil outlet.
Use the chain tensioning bolt (13) to move the
chain tensioning cam to the left-hand end stop.
Note:
Each time the guide bar is removed and
installed, adjust the chain tension cam (b) up to
the l.h. end stop.
On the models 656 and 656H the corresponding sprocket (enclosed with the accessories) for the
cutting gear should be installed. Notes on this can be found in the instructions included with the
accessories.
Always install matching components (sprocket, guide rail, saw chain) (see Chapter 9,
"Permissible cutting gear and further accessories", page 40).
Note for new saw chains:
Before installing a new saw chain we recommend soaking it in a container (bowl) with chain oil with
anti-fling properties for a certain amount of time (preferably overnight).
Position the guide bar; in the process, the
chain tensioning cam must fully engage in
the designated hole in the guide bar.
Fit the chain over the sprocket and into
the guide groove of the guide bar.
The cutting elements of the saw teeth
must be on the upper side of the rail
facing towards the tip of the rail.
Make sure that the drive links engage
correctly in the cutouts of the sprocket
and in the guide sprocket at the rail tip.
Fit the rail cover, but initially only tighten
the retaining nuts finger tight.
After correctly adjusting the chain tension (refer to the next section), tighten the retaining nuts as
described below.
13a / 13b: depending on the version
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 651 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 651 in the language / languages: English as an attachment in your email.

The manual is 1,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info